A.automated alternate routing (AAR)
B.Cisco CallManager Attendant Console
C.real-time protocol (RTP)
D.Survivable Remote Site Telephony (SRST)
您可能感興趣的試卷
你可能感興趣的試題
A.to support fault and policy reporting, the WLSE requires a Wireless Control System (WCS)
B.when WLSE detects an AP failure, it automatically increases the power and cell coverage of nearby APs
C.WLSE requires the 2700 location appliance to offer location tracking
D.WLSE can locate rogue APs and automatically shut them down
E.WLSE configuration is done using the command line interface (CLI) or a WEB based template
A.policy routing
B.increase link capacity
C.WRED
D.CBWFQ
E.LFI
F.WFQ
A.TKIP protects RC4 encryption keys
B.CKIP and TKIP protect AES encryption keys
C.TKIP encryption is more processor intensive than AES encryption is
D.WPA requires TKIP encryption, whereas WPA2 supports AES encryption
E.WPA requires AES encryption, whereas WPA2 supports TKIP encryption
A.a set of rules that can be established and associated with the ingress and egress ports of the control plane
B.improves performance of the control plane by marking control plane packets with DSCPEF
C.protects the control plane on a router from DoS attacks
D.treats the control plane as a separate entity with its own ingress (input) and egress (output) ports
E.provides the control plane with a separate token bucket
F.enhances security of the control plane by tunneling packets to and from the control plane
A.both WPA and WPA2 require authentication support via IEEE 802.1 x and Pre-Shared Key (PSK)
B.both WPA and WPA2 address all known Wired Equivalent Privacy (WEP) vulnerabilities in the IEEE 802.11i security implementation
C.WPA is supported on client devices only. WPA2 is supported on both access point (AP) and client devices
D.WPA provides only a standard for authentication. WPA2 provides a standard for authentication and encryption
E.WPA requires encryption support via Temporal Key Integrity Protocol (TKIP) WPA2 provides encryption support via (symmetric block cipher)AES-CCMP
A.WCS
B.WLSE
C.Location Appliance
D.WDS
E.WLSE-Express
A.set a minimum bandwidth guarantee
B.increase bandwidth
C.determine a specific transfer rate
D.establish timers
E.configure CBWFQ for best-effort traffic
F.set a maximum bandwidth limit
A.synchronizes FIFO, PQ, CQ, and MDRR, with WFQ, CBWFQ, and LLQ
B.enables strict priority queuing for voice traffic, and weighted round robin queuing for data traffic
C.enables low latency queuing to ensure that voice traffic receives priority treatment
D.enforces a trust boundary on switch access ports and uplinks/downlinks
E.modifies queue sizes as well as queue weights where required
F.adjusts link speeds to adapt to QoS needs
A.class-based policing is configured using the Modular QoS command-line (MQC)
B.only the Frame Relay traffic-shaping (FRTS) mechanism can interact with a Frame Relay network, adapting to indications of Layer2 congestion in the WAN links
C.Distributed Traffic Shaping (DTS) is configured with the police command under the policy map configuration
D.both Frame Relay traffic shaping (FRTS) and virtual IP (VIP)-based Distributed Traffic Shaping (DTS) have the ability to mark traffic
A.serialization delay
B.end-to-end delay
C.lack of bandwidth
D.inconsistent port costs
E.routing table convergence issues
F.poor file transfer rates
最新試題
In the design of a QoS solution, which two factors should be taken into consideration?()
Which two QoS classification and marking statements are true? ()
What are two ways to minimize the delay of VoIP packets that are traversing a network? ()
What can be used to maintain the voice quality on a link by limiting the number of calls that can be active at any given time?()
Which two statements are correct about the signaling methods that are utilized for transmitting voice? ()
Which three functions can an Integrated Services Router perform in a VoIP network?()
What are three factors used to determine the amount of bandwidth that is required for a single VoIP call? ()
Which two statements are true about Voice over IP (VoIP) packet delivery in a digital infrastructure? ()
When Cisco SDM is used to generate QoS policy, various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface? ()
For delay sensitive traffic, what are the three best ways that are used to prevent packet loss? ()