A.set a minimum bandwidth guarantee
B.increase bandwidth
C.determine a specific transfer rate
D.establish timers
E.configure CBWFQ for best-effort traffic
F.set a maximum bandwidth limit
您可能感興趣的試卷
你可能感興趣的試題
A.synchronizes FIFO, PQ, CQ, and MDRR, with WFQ, CBWFQ, and LLQ
B.enables strict priority queuing for voice traffic, and weighted round robin queuing for data traffic
C.enables low latency queuing to ensure that voice traffic receives priority treatment
D.enforces a trust boundary on switch access ports and uplinks/downlinks
E.modifies queue sizes as well as queue weights where required
F.adjusts link speeds to adapt to QoS needs
A.class-based policing is configured using the Modular QoS command-line (MQC)
B.only the Frame Relay traffic-shaping (FRTS) mechanism can interact with a Frame Relay network, adapting to indications of Layer2 congestion in the WAN links
C.Distributed Traffic Shaping (DTS) is configured with the police command under the policy map configuration
D.both Frame Relay traffic shaping (FRTS) and virtual IP (VIP)-based Distributed Traffic Shaping (DTS) have the ability to mark traffic
A.serialization delay
B.end-to-end delay
C.lack of bandwidth
D.inconsistent port costs
E.routing table convergence issues
F.poor file transfer rates
A.video conferencing traffic tends to be much more bursty in nature and is more prone to have an impact on other traffic flows
B.latency requirements are less stringent for video traffic than for voice traffic
C.video traffic is less sensitive to dropped packets than for voice traffic
D.video traffic requires the retransmission capabilities of TCP whereas voice uses UDP
E.video traffic tends to be much more bursty in nature and is more prone to have an impact on other traffic flows
F.voice traffic requires the retransmission capabilities of TCP whereas video uses UDP
A.the two steps of digital to analog conversion are decompression and reconstruction of the analog signal
B.the two steps of digital to analog conversion are decoding and filtering
C.the two steps of digital to analog conversion are decompression and filtering of the analog signal
D.the two steps of digital to analog conversion are quantization and decoding
A.Choose Configure >Access_Point, then enter the AP MAC address
B.Choose Configure >Access_Point, then enter the IP address of the AP
C.Wait until the WLC downloads its code from the WCS and choose the access point from the list under the WLC option of the Configure menu
D.Wait until the AP downloads its code from the WCS and choose the access point from the list under the Access_Point option of the Configure menu
A.the best-effort class will need to have its percentage entered in the QoS Policy Generation screen
B.SDM QoS wizard provides real-time validation of application usage of WAN bandwidth
C.the SDM wizard is not able to monitor QoS policing traffic
D.the SDM QoS wizard is pre-installed on enterprise routers
A.Cisco WCS Base and Cisco WCS Location both indicate rogue AP location only in a Rogue AP Alarm text file
B.Cisco WCS Base and Cisco WCS Location both indicate rogue AP location in a map at the most probable location that is calculated by two or more APs
C.Cisco WCS Base identifies the general location of rogue APs based on the signal strength received by the nearest managed Cisco APs, whereas Cisco WCS Location adds high-accuracy location tracking to within a few meters of the rogue AP
D.Cisco WCS Base does not have this feature, whereas Cisco WCS Location can indicate rogue AP location in a map at the most probable location that is calculated by two or more APs
E.Cisco WCS Base does not have this feature, whereas Cisco WCS Location can indicate rogue AP location in a map beside the nearest associated AP
A.end-to-end delay
B.interference from bulk data traffic
C.processing delays
D.serialization delays
E.jitter
A.centralized management for autonomous access points
B.centralized management for lightweight access points
C.integration with the Location Appliance to expand real time tracking to 1500 devices for 30 days
D.integration with the Location Appliance to expand real time tracking to 2500 devices for 15 days
E.the inclusion of an integrated AAA server F an external AAA-server requirement
最新試題
Which of the items stated is typically the most expensive method of improving QoS across WAN links?()
When Cisco SDM is used to generate QoS policy, various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface? ()
What are two reasons to implement H·323 gatekeepers?()
Which three benefits are realized by implementing Wireless LAN Solution Engine (WLSE)?()
Which two statements about the Wi-Fi Multimedia (WMM) standard are true?()
When QoS levels in the Cisco Wireless Control System (WCS) are entered, which profile names are used to identify the access categories?()
For delay sensitive traffic, what are the three best ways that are used to prevent packet loss? ()
Which option correctly identifies the four main menus of a Cisco Wireless Control System (WCS)? ()
Which two characteristics are common between traffic policing and traffic shaping?()
The Cisco SDM will create a QoS policy that provides services to two types of traffic. Which two statements indicate the default QoS parameters that are created by SDM?()