A. debug authentication
B. debug chap ppp
C. debug chap authentication
D. debug ppp authentication
您可能感興趣的試卷
你可能感興趣的試題
A. Layer 3
B. Layer 4
C. Layer 2
D. Layer 5
A. show ip ospf lsa database
B. show ip ospf link-state
C. show ip ospf neighbors
D. show ip ospf database
A. show ip access-list
B. show access-list
C. list ip interface
D. show interface
E. show ip interface
A. the switch with the lowest MAC address
B. the switch with the higest MAC address
C. the switch witch the higest IP address
D. the switch with the lowest IP address
A. to provide a mechanism to dynamically assign vlan membership to switch ports
B. to allow traffic to be carried from multiple vlans over a single link between switches
C. to allow native vlan information to be carried over a trunk link
D. to provide a mechanism to manually assign vlan membership to switch ports
E. to allow for managing the additions,deletions,and changes of vlans between switchs
A. service timestamps debug datetime msec
B. show clock detail
C. clock calendar-valid
D. service timestamps log datetime msec
A. source address and subnet mask
B. destination address and wildcard mask
C. source address and wildcard mask
D. destination address and subnet mask
A. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#no shut
B. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ietf Main(config-if)#no shut
C. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation frame-relay Main(config-if)#authenication chap Main(config-if)#no shut
D. Main(config)#interface serial 0/0 Main(config-if)#ip address 172.16.1.1 255.255.255.252 Main(config-if)#encapsulation ppp Main(config-if)#no shut
A. defines the source IP address that i s used in all broadcast packets on DLCI 202
B. defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
C. defines the destination IP address that is used in all broadcast packets on DLCI 202
D. defines the DLCI on which packets from the 192.168.1.2 IP address are received
A. anycast frames
B. multicast frames
C. broadcast frames
D. unicast frames
最新試題
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
On which options are standard access list based?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which command is used to display the collection of OSPF link states?()
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
At which layer of the OSI model is RSTP used to prevent loops?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()