A. any-to-many communication model
B. delivery of packets to the group interface that is closest to the sending device
C. one-to-many communication model
D. the same address for multiple devices in the group
E. one-to-nearest communication model
F. a unique IPV6 address for each device in the group
您可能感興趣的試卷
你可能感興趣的試題
A.HMAC-MD5
B.RSA
C.HMAC-SHA-1
D.DH1
E.DH2
A.reduced cost
B.bette rthroughput
C.increased security
D.scalability
E.reduced latency
F.broadband incompatibility
A. EIGRP converges fast RIP because of DUAL and backup routes that are stored in the topology table.
B. EIGRP uses a hello protocol to establish neighbor relationships
C. EIGRP uses split horizon and reverse poisoning to avoid routing loops.
D. EIGRP uses periodic updates to exchange routing information
E. EIGRP allows routers of different manufacturers to interoperate
F. EIGRP supports VLSM and authentication for routing updates.
G. EIGRP use a broadcast address to send routing information.
A. CHAP uses a two-way handshake
B. CHAP authentication periodically occurs after link establishment
C. CHAP has no protection from playback attacks
D. CHAP authentication is performed only upon link establishment
E. CHAP uses a three-way handshake
F. CHAP authentication passwords are sent in plaintext
A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6 header
E. chanage of source address in the ipv6 header
F. autoconfiguration
A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing
A.172.31.17.4/30
B.172.31.51.16/30
C.172.31.64.0/18
D.172.31.80.0/22
E.172.31.92.0/22
F.172.31.192.0/18
A. The number of FECN packets that are received by the router
B. The number of BECN packets that are received by the router
C. The ip address of the local router
D. The value of the local DLCI
E. The status of the PVC that is configured on the router
A. configure static frame relay map entries for each subinterface network.
B. remove the ip address from the physical interface
C. create the virtual interfaces with the interface command
D. configure each subinterface with its own IP address
E. disable split horizon to prevent routing loops between the subinterface networks
F. encapsulate the physical interface with multipoint PPP
A.show inventory
B.show flash:filesys
C.dirflash:include chassis
D.show diag
E.show controllers
最新試題
At which layer of the OSI model is RSTP used to prevent loops?()
At which layer of the OSI model dose PPP perform?()
Which command encrypts all plaintext passwords?()
Which statement describes the rule of split horizon?()
Which statement is true, as relates to classful or classless routing?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which command displays the CHAP authentication process as it occurs between two routers?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
Which pairing reflects a correct protocol-and-metric relationship?()