A.0ms
B.10ms
C.500ms
D.1s
E.5s
F.30s
您可能感興趣的試卷
你可能感興趣的試題
A.Site Of Origin SOO
B.Route-Target
C.Route-Distinguisher
D.Domain Identifier BGP extended commumity
A.router（config）#
B.router（config-if）#
C.router（config-vrf）#
D.router（config-router）#
E.router（config-router-af）#
A.EtherChannel technology helps aggregate traffic grouping multiple，full-duplex point-to-point linkstogether
B.EtherChannel technology is based on the 802.1 IEEE stand
C.EtherChannel can aggregate up to 800 Mbps，8 Gbps，or Gbps of aggregate bandwidth for a Fast EtherChannel，Gigabit EtherChannel，or 10 Gigabit EtherChannel connection respectively
D.EtherChannel is defined for Rapid Spanning Tree for faster convergence
A.Uniform model
B.Pipe Model
C.Short Pipe
D.None of the above will alter Differentiated Services（Diff-Serv）code points set in different DifferentiatedServices（Diff-Serv）domain
A.Greater scalability is offered
B.The ASBR holds VPNv4 routes
C.Relative technical simplicity is offered
D.Lower relative security is offered
E.Multihop E-BGP between ASBRs is utilized
F.Better suitability for InterProvider VPNs is provided
A.LDP is primarily used in internal networks of MPLS-VPN providers.
B.MP-BGP is used for label distribution for VPN customer routes.
C.Directed LDP is used for label distribution in L2-VPN Attachement Circuits.
D.MP-BGP is used for label distribution in MPLS Traffic Engineered networks.
A.Amplification is prevented if global changes have only a local effect as opposed to systems in which global changes have a local effect
B.Amplification is prevented if local changes have only a local effect as opposed to system inwhich localchange have a global effect
C.Internet domain does not suffer from“The Amplification Principle”as BGP takes care of misbehaving advertisers
D.None of the above
A.Following a link flap in the BGP speaker’s AS
B.During initial convergence.
C.Following a Route Processor Switchover.
D.Just before sending a CEASE message to tear down the session.
E.During capability negotiation
A.cs3
B.cs7
C.ef
D.af41
E.af31
F.0（default）
A.It is used for PIM control traffic
B.It is optionally configured for a high bandwidth multicast source to reduce multicast traffic replication to uninterested PE routers
C.Within the VPF configuration in the PE router， multiple Default MDT groups are configured so each VPF can support multiple multicast sources
D.There is a reduced multicast state in the MPLS core P routers
E.When multicast traffic exceeds a certain configured threshold， traffic from the Data MDT is switched to the Default MDT to conserve bandwidth
最新試題
Assume that the PEs are separated by Multiple P routers.How many labels should the ingress PE push for BPE functionality？（）
Which option is not a valid method to assign the lowest-order 64-bit field of an IPv6 unicast address？（）
What are three common reasons for ATM CRC errors？（）
Which statement about the use of Route Target Rewrite is true？（）
Which four statements about Ethernet virtual circuit （EVC） infrastructure are true？ （）
Which two statements about Layer 3 MPLS VPN are true？（）
All secure domain routers （SDRs） have shared attribute and resources. Which three resources are sharedall SDRs？ （）
Two islands of IPv6 networks that are running ISIS （IPv6 IGP） must be connected using a tunnel over anIPv4 network. Which tunneling method can be used to achieve this goal？（）
Which three protocols use TLVs to carry attributes？（）
What is the BGP synchronization rule？（）