A.Amplification is prevented if global changes have only a local effect as opposed to systems in which global changes have a local effect
B.Amplification is prevented if local changes have only a local effect as opposed to system inwhich localchange have a global effect
C.Internet domain does not suffer from“The Amplification Principle”as BGP takes care of misbehaving advertisers
D.None of the above
您可能感興趣的試卷
你可能感興趣的試題
A.Following a link flap in the BGP speaker’s AS
B.During initial convergence.
C.Following a Route Processor Switchover.
D.Just before sending a CEASE message to tear down the session.
E.During capability negotiation
A.cs3
B.cs7
C.ef
D.af41
E.af31
F.0(default)
A.It is used for PIM control traffic
B.It is optionally configured for a high bandwidth multicast source to reduce multicast traffic replication to uninterested PE routers
C.Within the VPF configuration in the PE router, multiple Default MDT groups are configured so each VPF can support multiple multicast sources
D.There is a reduced multicast state in the MPLS core P routers
E.When multicast traffic exceeds a certain configured threshold, traffic from the Data MDT is switched to the Default MDT to conserve bandwidth
A.Logging detect fail-login
B.Login on-failure log
C.Login detect login-failure log
D.Logging login on-failure
E.none of the above
A.GFC-4 bits of generic flow control
B.Forward-explicit congestion notification(FECN)
C.VCI-16 bits of virtual channel identifier
D.CLP-1 bit of congestion loss
E.HEC-8 bit of header error control
F.ATM Discard Eligibility(DE)bit
A.lowest cost
B.highest bandwidth
C.lowest hop-count
D.path attributes
E.lowest delay
A.It prevents message looping,Session Advertisement(SA)messages must be RPF checked
B.RPF check should be done against the route to the Rendez-vous Point of the corresponding PIM-SM domain,which originated the SA
C.RPF checking Session Advertisement(SA)messages will cause message looping
D.RPF check should be done against the route to the source S of the corresponding PIM-SM domain
A.LDP and RSVP
B.RSVP and CEF
C.CEF and the FIB table
D.UDP and IP
E.A and B
A.LSA type 1
B.LSA type 2
C.LSA type 7
D.LSA type 3
E.LSA type 9
F.LSA type 5
A.Packet mode
B.Frame mode
C.Transparent mode
D.Channel mode
E.Tunnel mode
最新試題
Which two statements about Layer 3 MPLS VPN are true?()
What method of streaming live video is the least taxing on bandwidth in a large enterprise environment?()
There are two cabling schemes to choose from when implementing a Cisco CRS-1 multishelf system:single-module cabling and multimodule cabling. What is the maximum capacity of the LCCs that aresupported in multimodule cabling?()
Which statement about VPLS is true?()
Cisco IOS XR Software Multicast Routing Implementation, which three features are supported in IPv6 onCisco CRS router?()
What layer of the TMN (telecommunications management network) model does CTM fit into?()
When an MPLS Layer 2 VPN runs in the hub-and-spoke model, where is QoS implemented?()
Which statement about implementing the Cisco IPv6 provider Edge Router over MPLS is true?()
In the Carrier Supporting Carrier (CsC) feature, which two protocols run between CSC-PE and CSC-CE().
Which of the following is used to periodically multicast by DIS on a LAN to ensure IS-IS link state databaseaccuracy?()