A. FabricPath provides MAC address scalability with conversational learning
B. Loop mitigation with TTL in the frame field
C. STPl independence
D. 10 Gbps bandwidth
E. Layer 2 extensions between data centers
您可能感興趣的試卷
你可能感興趣的試題
A. FabricSync is used to synchronize MAC addresses to an adjacent fabric interconnect after a server interface failover.
B. Gratuitous ARPs are sent on fabric interconnect uplinks after a server interface failover.
C. Fabric failover can be used on vNICs and vHBAs.
D. Fabric failover is configured as part of the service profile.
E. Fabric interconnects in end-host mode use fabric failover instead of spanning tree to provide redundancy on uplink ports.
A. ACE sticky license is not installed
B. ACE stickiness is not supported in a non-admin context
C. ACE stickiness resources are not defined in an admin context
D. Stickiness is configured properly in the CCIE virtual context
A. Only to Cisco Fibre Channel switches
B. Only to Cisco Fibre Channel switches in NPIV mode
C. To any Fibre Channel switch
D. Directly to storage arrays
E. Only to Nexus Switches
What is the purpose of this command in a Cisco Application Control Engine？（）
switch/Admin# show np 1 me-stats "-F0 v"
A. It displays the status of the internal SSL proxy structure associated with a vserver.
B. It displays the crypto-related statistics for a single NP.
C. It is the same output of a "show stats crypto" client/server.
D. It shows details on HTTP session entries.
What would be the cause for the following fault in UCS Manager？（）
"ether VIF x / xxx down， reason： ENM source pinning failed"
A. The associated VLANs of a vNIC are not found on an uplink.
B. Overlapping VLAN IDs exist on upstream disjoint networks.
C. The vNIC was not configured for fabric failover.
D. The vNIC is pinned to the wrong fabric.
E. Overlapping VSAN IDs exist on upstream SAN switches.
F. The vHBA was not configured for failover.
A. Interface inbound-low handles Rx and Tx of low-priority control packet
B. Interface inbound-lo handles Rx and Tx of high-priority control packet
C. Interface inbound-low maps to internal interface eth3
D. Interface inbound-low maps to internal interface eth4
A. Client IP
B. Proxy IP
C. Client and proxy IP
D. Neither client nor proxy IP
A. HTTP
B. Java scripting
C. TCL scripting
D. RADIUS
E. TACACS
A. An interface ’san-port-channel’ in NXOS
B. An interface ’port-channel’ in NXOS
C. An interface ’port-channel’ with ’mode fc’ configured
D. An interface ’fc-port-channel’ in NXOS
A. UCS-A# show pinning border-interfaces
B. UCS-B# show service-profile circuit
C. UCS-B（nxos）# show pinning server-interfaces
D. You must statically configure which uplink the blades should use， or you will not have connectivity.
最新試題
Which GSS "source access list" is used to allow access to GSS by clients when GSS is being used as the DNS？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
KAL-AP on the Cisco ACE allows communication with Cisco ACE Global Site Selector， to report virtual IP and real server availability. Which statement is true about KAL-AP？（）
Application Control Engine （ACE） can check the health of servers and server farms by configuring health probes （which are sometimes referred to as keepalives）. A probe can be one of many types. Which are valid ACE probes？ （）
Which statement is true regarding Backup tasks in Cisco UCS？（）
In a Cisco Unified Computing System， where are SAN port channels connected to？（）
Refer to the exhibit.Your company requires a Cisco UCS configuration that will， at a minimum， allow the configuration in the provided exhibit. Which Cisco UCS components will meet the requirement？（）
A Cisco UCS fabric interconnect in end-host mode learns MAC addresses on which port types？（）