多項選擇題An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue，choose two possible causes.（）

A.Incorrect VTP domain
B.Incorrect VTP password
C.Incorrect VTP mode
D.Incorrect VTP configuration revision


您可能感興趣的試卷

你可能感興趣的試題

3.問答題SRR？
4.單項選擇題

Refer to the exhibit. BGP-4 routing to the Internet，in normal behavior，may create asymmetrical routing for different prefixes. The BGP routing table indicates that traffic should follow the paths indicated in the exhibit，but packets are not going further than the border router in AS 4. What could be the cause of this problem？（）

A.TCP Intercept is configured in AS 4.
B.Unicast Reverse Path Forwarding is configured in loose mode in this router.
C.Packets may be leaving AS 1 without the BGP routing flag set to 1.
D.Unicast Reverse Path Forwarding is configured in strict mode in this router.
E.There is a missing Unicast Reverse Path Forwarding configuration.

6.問答題WRR？
8.問答題what is LFI？
10.多項選擇題The network administrator is trying to add Switch1 to the network， but the 802.1Q trunk is not coming up. Switch1 was previously tested in the laboratory and its trunk configuration worked fine. What are three possible causes of this problem？ （）

A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.