您可能感興趣的試卷
你可能感興趣的試題
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q.
Refer to the exhibit. Two ISPs have decided to use MSDP and configured routers X and Y (both are PIM RPs) as MSDP peers. In the domain of ISP B, PC A has sent an IGMP membership report for the group 224.1.1.1 and PC B has sent an IGMP membership report for the group 224.5.5.5. Assuming that the MSDP peering relationship between routers X and Y is functional, and given the partial configuration output shown from router X, which two of these statements are true?()
A.Router X will contain an entry for 224.1.1.1 in its SA cache and will also have an installed (S,G) entry for this in its mroute table.
B.Router X will not contain an entry for 224.1.1.1 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
C.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (S,G) entry for this in its mroute table.
D.Router X will not contain an entry for 224.5.5.5 in its SA cache but will have an installed (*,G) entry for this in its mroute table.
E.Router X will have no entries for 224.5.5.5 in neither its SA cache nor in its mroute table.
F.Router X will have no entries for 224.1.1.1 in neither its SA cache nor in its mroute table.
最新試題
What is method list for configure aaa?
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?()
aaa架構(gòu)中哪個是要求用戶輸入用戶名和密碼?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
What is the next state of initial in spanning-tree protocol?
what is four ospf area type?
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?()
what is the disadvantage of policing?
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?()