A. They are used to summarize area routes to other areas.
B. They are used in not-so-stubby areas to propagate external routes.
C. They are used to notify areas of the ASBR.
D. They are flooded to all areas except stub areas （external route）.
您可能感興趣的試卷
你可能感興趣的試題
A.00000
B.12345
C.23456
D.65000
E.99999
A. The Layer 2 multicast address of the destination node
B. The solicited node multicast address of the destination node
C. The Layer 2 address of the destination node based on the destination IPv6 address
D. The IPv6 address of the destination node based on the destination Layer 2 address
A.6to4
B.6over4
C.ISATAP
D.GRE
A.0.0.0.1
B.0.255.0.1
C.2001：DB8：：1
D.2001：DB8：ABCD：FEEF：：1
A.2001：DB8：：1 and 2001：DB8：：2
B.2001：DB8：：9 and 2001：DB8：：10
C.2001：DB8：：10 and 2001：DB8：：17
D.2001：DB8：：1 and 2001：DB8：：18
A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.
A. anycast address
B. site-local multicast
C. global address of the link
D. unique local address
E. link-local address
A.On-Passive
B.On-Auto
C.Passive-Active
D.Desirable-Auto
E.Active-Active
F.Desirable-Desirable
A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information
A. An IPv4-compatible tunnel is a static tunnel， but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers， but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains， but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel， the ISP assigns only IPv4 addresses for each domain， but for a 6to4 tunnel， the ISP assigns only IPv6 addresses for each domain.
最新試題
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
Which three options are valid ways to filter routes from a BGP peer？（）
Which two EIGRP options will limit a query domain？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Which two statements about SA caching are true？（）