A.configure a hard-to-guess VTP domain name
B.use a hard-to-guess VTP password
C.use VTP transparent mode
D.implement VTP version 3
您可能感興趣的試卷
你可能感興趣的試題
A. prefixes received from any other BGP peer and prefixes locally originated via networkstatements or redistributed to BGP
B. all prefixes in its IP routing table
C. only prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. only prefixes received from EBGP peers and prefixes received from route reflectors
E. all prefixes in its routing table except the prefixes received from other EBGP peers
F. all prefixes in its routing table except the prefixes received from other IBGP peers
A.excessive collisions
B.FCS errors
C.runts
D.late collisions
A.interface gig3/1 spanning-tree guard root
B.interface gig3/1 spanning-tree root guard
C.interface gig3/1 spanning-tree root-guard
D.interface gig3/1 spanning-tree root-guard default
A. prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed
B. all prefixes in its routing table
C. prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. prefixes received from EBGP peers and prefixes received from route reflectors
E. prefixes received from other IBGP peers, prefixes received from EBGP peers, and prefixes redistributed to BGP
F. prefixes received from other IBGP peers and prefixes received from route reflectors
A.802.1s supports a reduced number of spanning-tree instances.
B.802.1s has better convergence times than 802.1w.
C.802.1s does not support load balancing over the same physical topology.
D.The CPU utilization for 802.1s is lower than the CPU utilization for 802.1w.
A.service timestamps log datetimec msec
B.logging timestamps msec
C.syslog timestamps hour minute second miliseconds
D.service logging timestamp msec
E.logging service timestamp msec
A.version 1
B.version 5
C.version 7
D.version 8
E.version 9
A.ip sla 1 icmp-echo 1.1.1.1 tos 12
B.ip sla 1 icmp-echo 1.1.1.1 tos 96
C.ip sla 1 icmp-echo 1.1.1.1 precedence 3
D.ip sla 1 icmp-echo 1.1.1.1 dscp 12
A.ip sla monitor low-memory
B.ip sla group schedule
C.ip sla reaction-trigger
D.ip sla enable timestamp
Refer to the exhibit. In this network, R1 is configured not to perform autosummarization within EIGRP. What routes will R3 learn from R2 through EIGRP? ()
A. 172.30.1.0/24 and 10.1.2.0/24;EIGRP only performs autosummarization at the edge between two major networks.
B. 172.30.0.0/16 and 10.1.2.0/24;R2 will perform autosummarization although R1 will not.
C. Since R2 is configured without autosummarization, it will not propagate the 172.30.1.0/24 route.
D. 172.30.0.0/8 and 10.0.0.0/8.
最新試題
Which three message types are valid PIMv2 message types?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()
What is also called Type 0 authentication in OSPF on Cisco Routers?()
What is true about Unicast RPF in strict mode?()
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()
In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()
Choose two commands that are required to enable multicast on a router, when it is known that thereceivers use a specific functionality of IGMPv3.()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()
Which three protocols or applications should be placed in a class that is configured with WRED?()