A.Forwarding Address
B.External Route
C.Reference Link-State ID
D.Option
E.Prefix Options
您可能感興趣的試卷
你可能感興趣的試題
A. The trunking configuration mode on Switch1 is set to Off.
B. The trunking configuration mode on the other end is set to On.
C. The trunking configuration mode on the other end is set to Desirable.
D. Cisco Discovery Protocol is not running on the other end.
E. There is a VTP domain name mismatch.
F. Switch1 does not support 802.1Q
A.It allows the standby RP to take control of the device after a hardware or software fault on the active RP.
B.It is a Layer 3 function that works with SSO to minimize the amount of time a network is unavailable tousers following a switchover.
C.It is supported by the implementation of EIGRP, OSPF, RIPv2, and BGP protocols.
D.It synchronizes startup configuration, startup variables, and running configuration.
E.The main objective of NSF is to continue forwarding IP packets following a switchover.
F.Layer 2 802.1w or 802.1s must be used, as 802.1d cannot process the Layer 2 changes.
G.Routing protocol tuning parameters must be the same as the NSF parameters, or failover will beinconsistent.
A. The VSS switch must be the root bridge for all VLANs and is automatically designated
B. The VSS switch is defined in RFC 4318 as a managed object
C. The PAgP+ or LACP protocols are used to maintain the operational state of the VSS devices
D. A VSS interoperates with a virtual port channel
E. The 802.1Q or ISL protocols are used to maintain the operational state of the VSS devices
F. A VSS increases the size of the spanning-tree domain
A.telnet 11.1.1.4 /vrf-source red
B.telnet 11.1.1.4 source /vrf red
C.telnet 11.1.1.4 /source vrf red
D.telnet 11.1.1.4 /vrf red
E.telnet 11.1.1.4 vrf red
A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table
A.ip vrf CCIE
B.ipv6 vrf CCIE
C.vrf definition CCIE
D.ipv6 vrf definition CCIE
Refer to the exhibit. From the MAC addresses shown in the command output, to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch? ()
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
A.0
B.1
C.255
D.256
A.6to4
B.6over4
C.ISATAP
D.6PE
E.GRE
A. Both support normal and extended VLAN ranges.
B. ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.
C. ISL encapsulates the original frame.
D. Both support native VLANs.
E. 802.1Q does not encapsulate the original frame.
最新試題
Which two statements are true about RED?()
What is true about Unicast RPF in strict mode?()
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"?()
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()
Which of the following is true about the MPLS header and its EXP field size?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()
Which two statements about SA caching are true?()
Which of these statements about penultimate hop popping are true?()
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()