A.telnet 11.1.1.4 /vrf-source red
B.telnet 11.1.1.4 source /vrf red
C.telnet 11.1.1.4 /source vrf red
D.telnet 11.1.1.4 /vrf red
E.telnet 11.1.1.4 vrf red
您可能感興趣的試卷
你可能感興趣的試題
A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table
A.ip vrf CCIE
B.ipv6 vrf CCIE
C.vrf definition CCIE
D.ipv6 vrf definition CCIE
Refer to the exhibit. From the MAC addresses shown in the command output， to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch？ （）
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
A.0
B.1
C.255
D.256
A.6to4
B.6over4
C.ISATAP
D.6PE
E.GRE
A. Both support normal and extended VLAN ranges.
B. ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.
C. ISL encapsulates the original frame.
D. Both support native VLANs.
E. 802.1Q does not encapsulate the original frame.
A.EIGRPv6 will form a neighbor relationship.
B.EIGRPv6 will not form a neighbor relationship.
C.EIGRPv6 will form a neighbor relationship， but with the log MSG： "EIGRPv6 neighbor not on a commonsub net."
D.EIGRPv6 will form a neighbor relationship， but routes learned from that neighbor will not be installed inthe routing table.
A. It supports autonegotiation for both ISL and IEEE 802.1Q trunks.
B. It must be disabled on an interface if you do not want the interface to work as a trunk or start negotiation to become a trunk.
C. It is a point-to-multipoint protocol.
D. It is a point-to-point protocol.
E. It is not supported on private VLAN ports or tunneling ports.
A.link local
B.area wide
C.AS wide
D.reserved
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
最新試題
In GLBP，which router will answer on client ARP requests？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
Which two statements are true about RED？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）