A.0
B.1
C.2
D.3
E.4
您可能感興趣的試卷
你可能感興趣的試題
A.ip route 0.0.0.0 0.0.0.0 s0/0/0
B.ip route 0.0.0.0 0.0.0.0 209.165.200.226
C.ip route 209.165.200.0 255.255.255.0 192.168.1.250
D.ip route 192.168.1.0 255.255.255.0 209.165.100.250
A.using adapters and access points manufactured by the same company
B.overlapping the wireless cell coverage by at least 10%
C.configuring all access points to use the same channel
D.utilizing MAC address filtering to allow the client MAC address to authenticate with the surrounding APs
A.AES-CCMP
B.PPK via IV
C.PSK
D.TKIP/MIC
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
A.Layer 2
B.Layer 3
C.Layer 4
D.Layer 5
E.Layer 6
F.Layer 7
A.By default, all defined VLANs are allowed on the trunk.
B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C.Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D.Each single VLAN, or VLAN range, must be specified with the vlan database command.
最新試題
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
Which command encrypts all plaintext passwords?()
Which command displays the CHAP authentication process as it occurs between two routers?()
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()
What is the purpose of the cisco Vlan Trunking protocol?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
Which command is used to display the collection of OSPF link states?()
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()