Refer to the exhibit.Assume that the routing protocol referenced in each choice below is configured with its default settings and the given routing protocol is running on all the routers. Which two conditional statements accurately state the path that will be chosen between networks 10.1.0.0 and 10.3.2.0 for the routing protocol mentioned？ （）
A.If OSPF is the routing protocol， the path will be from R1 to R3 to R4 to R5.
B.If OSPF is the routing protocol， the path will be from R1 to R2 to R5.
C.If OSPF is the routing protocol， the path will be from R1 to R5.
D.If RIPv2 is the routing protocol， the path will be from R1 to R3 to R4 to R5.
E.If RIPv2 is the routing protocol， the path will be from R1 to R5.
您可能感興趣的試卷
你可能感興趣的試題
A.2 through 1001
B.1 through 1001
C.1 through 1002
D.2 through 1005
Refer to the exhibit. SW1 and SW2 have default configurations. What will happen if host 1 sends a broadcast？（）
A. Hosts 2， 3， and 4 will receive the broadcast.
B. Hosts 1， 2， 3， and 4 will receive the broadcast.
C. Host 2 and the Fa0/0 interface of R1 will receive the broadcast.
D. Hosts 1， 2 and the Fa0/0 interface of R1 will receive the broadcast.
E. Hosts 1， 2， 3， 4 and interface Fa0/0 of R1 will receive the broadcast.
F. Hosts 2， 3， 4， and interfaces Fa0/0 and Fa0/1 of R1 will receive the broadcast.
A.(config-if)#authentication ppp chap fallback ppp
B.(config-if)#authentication ppp chap pap
C.(config-if)#ppp authentication chap pap
D.(config-if)#ppp authentication chap fallback ppp
A.Bandwidth,Delay,and MTU
B.Bandwidth
C.Bandwidth and MTU
D.Bandwidth , MTU,Reliability,Delay,and Load
Refer to the exhibit. A packet with a source IP address of 192.168.2.4 and a destination IP address of 10.1.1.4 arrives at the HokesB router. What action does the router take？（）
A. forwards the received packet out the Serial0/0 interface
B. forwards a packet containing an EIGRP advertisement out the Serial0/1 interface
C. forwards a packet containing an ICMP message out the FastEthernet0/0 interface
D. forwards a packet containing an ARP request out the FastEthernet0/1 interface
A.decreasing the number of collision domains
B.filtering frames based on MAC addresses
C.allowing simultaneous frame transmissions
D.increasing the size of broadcast domains
E.increasing the maximum length of UTP cabling between devices
A.reflexive
B.extended
C.standard
D.dynamic
A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.
A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users.
A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.
最新試題
要將數據包發送到遠程網絡，應使用哪種設備？（）
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程？（）
請參見圖示。下列哪組設備僅包含中間設備？（）
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是，從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題？（）
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet?？梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址？（）
在Cisco IOS 設備中，啟動配置文件存儲于何處？（）
請參見圖示。當計算機A 向計算機D 發送幀時，哪些計算機會接收該幀？（）
請參見圖示。一臺路由器（其路由表如圖所示）收到發往192.168.1.4的數據包。路由器將如何處理該數據包？（）
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口？（）
何時必須使用clock rate 命令配置路由器串行接口？（）