A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users.

A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.

A.redundant
B.spanned
C.provisioned
D.converged

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

A.Check the trunk encapsulation mode for SwitchC’s fa0/1 port.
B.Check the duplex mode for SwitchC’s fa0/1 port.
C.Check the duplex mode for SwitchA’s fa0/2 port.
D.Check the trunk encapsulation mode for SwitchA’s fa0/2 port.

A.NCP
B.LCP
C.ISDN
D.DLCI
E.SLIP

A. The next routing update can be expected in 35 seconds. 
B. The IP address 10.10.10.6 is configured on S0/1. 
C. The IP address 10.10.10.8 is configured on S0/1.
D. This route is using the default administrative distance. 
E. The 10.10.10.8 network is two hops away from this router.

A.Microsegmentation decreases the number of collisions on the network.
B.if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C.Spanning Tree Protocol allows switches to automatically share vlan information.
D.In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E.Establishing vlans increases the number of broadcast domains.
F.Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

A.Configure the no ip subnet-zero command on R1,R2,and R3.
B.Dynamic routing protocols such as RIPv2 cannot be used across Frame Relay networks.
C.Configure the S0/0 interface on R1 as two subinterfaces and configure point-to-point links to R2 and R3.
D.Change the 172.16.2.0/25 and 172.16.2.128/25 subnetworks so that at least two bits are borrowed from the last octet.
E.Change the network address configuration to eliminate the discontiguous 172.16.2.0/25 and 172.16.2.128/25 subnetwork.