A.10.10.0.0/18 subnetted with mask 255.255.255.252
B.10.10.0.0/25 subnetted with mask 255.255.255.252
C.10.10.0.0/24 subnetted with mask 255.255.255.252
D.10.10.0.0/23 subnetted with mask 255.255.255.252
E.10.10.0.0/16 subnetted with mask 255.255.255.252
您可能感興趣的試卷
你可能感興趣的試題
A.映射本地IP到對端端口值,以便路由器發送數據時確認發送端口
B.映射本地IP到本地端口值,以便路由器發送數據時確認發送端口
C.映射對端IP到本地端口值,以便X.25交換網絡查找數據發送路徑
D.映射對端IP到對端端口值,以便X.25交換網絡查找數據發送路徑
A.150.150.0.0
B.150.150.0.8
C.150.150.8.0
D.150.150.16.0
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? ()
A.Core2(config)# interface f0/0 Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
A.a primary route,stored in the routing table
B.a backup route,stored in the routingt able
C.a backup route,stored in the topology table
D.A primary route,stored in the topology table
A.子網掩碼
B.源網絡地址
C.目的網絡地址
D.下一跳地址
A.應用層
B.表示層
C.會話層
D.傳輸層
E.網絡層
F.鏈路層
G.物理層
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
最新試題
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
OSI 模型的哪兩項功能在第2層實現?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
OSI 哪一層可提供有序的數據重構服務?()
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()