您可能感興趣的試卷
你可能感興趣的試題
A.150.150.0.0
B.150.150.0.8
C.150.150.8.0
D.150.150.16.0
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
The switches shown in the diagram, Core and Core2, are both Catalyst 2950s. The addressing scheme for each company site is as follows:Router Ethernet port - 1st usable addressCore - 2nd usable addressCore2 - 3rd usable addressFor this network, which of the following commands must be configured on Core2 to allow it to be managed remotely from any subnet on the network? ()
A.Core2(config)# interface f0/0 Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8
A.a primary route,stored in the routing table
B.a backup route,stored in the routingt able
C.a backup route,stored in the topology table
D.A primary route,stored in the topology table
A.子網掩碼
B.源網絡地址
C.目的網絡地址
D.下一跳地址
A.應用層
B.表示層
C.會話層
D.傳輸層
E.網絡層
F.鏈路層
G.物理層
A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer
A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.
A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached
B.Router C will use ICMP to inform Router B that Host 2 cannot be reached
C.Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached
D.Router C will send a Destination Unreachable message type
E.Router C will send a Router Selection message type
F.Router C will send a Source Quench message type
最新試題
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
在路由器上使用Router#copy running-config startup-config 命令會產生什么效果?()
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()
請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()
OSI 模型的哪兩項功能在第2層實現?()
要將數據包發送到遠程網絡,應使用哪種設備?()
路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()