A.lost connection to the controller
B.duplicate IP address
C.startup
D.site survey mode
您可能感興趣的試卷
你可能感興趣的試題
A.Enable Self-Healing.
B.Configure Location Manager.
C.Conduct Client Walkabout.
D.Conduct Radio Scan.
A.Disable Auto RF and configure manually.
B.Disable all 802.11b data rates.
C.Power access point to full power.
D.Hard code the channel.
A.Infrastructure devices to associate only to this SSID
B.Enable IP redirection on this SSID
C.Set Data Beacon Rate
D.Multiple Basic Service Set Identification （BSSID）
E.Set infrastructure SSID
A.EAP-PEAP
B.EAP-FAST
C.EAP-Cisco Wireless （LEAP）
D.EAP-TLS
E.EAP-MD5
A.15
B.10
C.1
D.5
The IOS of a North American Cisco Aironet 1230 Series access point has become corrupt，
necessitating the need for a TFTP firmware reload.
Before you press and hold the MODE button，what must the file be named in order for the reload to occur？（）
A.c1200-k9w7-tar.default
B.c1200-k9w7-tar.boot
C.c1200-k9w7-tar.123-7.JA1.tar
D.c1200-k9w7-tar.recover
During the installation of the Cisco WCS， an error occurs.
Where will the installation log be found？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
A lightweight access point has been connected to a Catalyst 3550 24-PWR switch， and on power-up the access point fails.
What is the problem with the switch？（）
A.The power supply has inadequate wattage.
B.Power is incorrectly configured on the port.
C.It does not support 802.3af Poe.
D.Power is not enabled on the port.
Two access points running the core feature set are connected to the same switch and are providingguest services.
If PSPF is enabled， what must be enabled on the switch to prevent clients fromseeing one another’s data？（）
A.port-based RADIUS
B.802.1q trunking
C.inline power
D.protected port
A.startup
B.site survey mode
C.lost connection to the controller
D.duplicate IP address
最新試題
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
A Cisco Wireless Location Appliance has been added to track RFID tags placed on laptops beingused in a school.Classrooms at the school have concrete block walls. During testing，you discoverthat the accuracy of the system needs to be improved.You decide to edit the map in the Cisco WCS to add the interior walls.How many interior walls can you add to improve the accuracy of thelocation appliance？（）