A.transaction
B.icmp
C.discovery
D.nd
您可能感興趣的試卷
你可能感興趣的試題
A. time stamp
B. error codes
C. severity level
D. log message name
A. show port network
C. show controllers Ethernet-controller
A. providing loop-free technology.
B. providing HSRP/VRRP.
C. managing additional routing peers.
D. managing two nodes and configuration.
You are working with a client to deploy QoS on their Frame Relay WAN. They would like to be able to allow packets to cross the Frame Relay WAN but have them marked as discard eligible if they exceed the QoS policy.
How would you accomplish this task?（）
A. Configure a class map that sets the DE bit so that the policy map can correctly apply a violate-action if the policy is exceeded.
B. Configure a service policy that sets the DE bit and apply it to the serial interface connected to the Frame Relay WAN.
C. Configure a policy map that has a burst-max action of setting the DE bit if the policy is exceeded.
D. Configure a policy map that has a violate-action to change the DE bit from 0 to 1.
A. advanced integration module
B. FICON ports
C. Cisco CallManager 5.0 support
D. warm Cisco IOS upgrade feature
A. Re-learn the available OSPF neighbors with neighbor relationship restart
B. Send the graceful restart message
C. Re-acquire the link state database content for the network
D. Re-learn the available OSPF neighbors without neighbor relationship restart
A. to configure a subinterface so that it can be applied to the primary interface in order to prevent exponential selective dampening
B. to suppress the effects of excessive interface flapping events on routing protocols and routing tables in the network
C. to introduce a nonconfigurable exponential delay mechanism
D. to allow the network operator to configure a router to automatically dampen and selectively identify a local interface that is failing
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.
Which two of these are possible causes? （）
A. Bandwidth statements do not match
B. MTUs do not match
C. IP Addresses are not in the same subnet
D. CHAP passwords do not match
A. flags indicating the kind of autoconfiguration that can be done by hosts
B. default router information
C. /64 prefix that can be used on the link and the lifetime of the prefix
D. IPv6 DHCP server address information
最新試題
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
When a Cisco router is configured for SSH, it acts as an （）?
In a RSTP implementation, which of the following two link types are used? （）(Choose two.)
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
Which of the following allows network administrators to easily apply common services and employ features across Cisco switches, routers, and access points with an intuitive GUI?（）