A. The eBGP peer neighborship uses TCP
B. The eBGP peer uses port 180 (default)
C. The eBGP peer uses the same ASN as the local router
D. The eBGP peer updates its AS_Path PA before sending updates to this router
您可能感興趣的試卷
你可能感興趣的試題
A. 1
B. 65,000
C. 64,000
D. 64,550
A. 22
B. 11
C. 1
D. None
Class C network 200.1.1.0/24 was allocated to an ISP that operated primarily in AsiA.That ISP then assigned this entire Class C network to one of its Asian customers. Network 200.1.2.0/24 has yet to be assigned to any ISP.
Which of the following is most likely to be true?（）
A. 200.1.2.0/24 could be assigned to any registrar or ISP in the worlD
B. 200.1.2.0/24 will be assigned in the same g eography (Asia) as 200.1.1.0/24
C. 200.1.2.0/24 cannot be assigned as public address spacE
D. Routers inside North American ISPs increase their routing table size by 1 as a result of the customer with 200.1.1.0/24 connecting to the Internet
A. 192.16.1.1
B. 172.35.1.1
C. 225.0.0.1
D. 127.0.0.1
E. 10.1.1.1
The following output occurs on Router R1. IP SLA operation 1 uses an ICMP echo operation type, with default frequency of 60 seconds. The operation pings from address 1.1.1.1 to address 2.2.2.2. Which of the following answers is true reg arding IP SLA and object tracking on R1?（）
R1# show track
Track 2
IP SLA 1 state
State is Up
3 changes, last change 00:00:03
Delay up 45 secs, down 55 secs
Latest operation return code: OK
Latest RTT (millisecs) 6
Tracked by:
STATIC - IP - ROUTING 0
A. The tracking return code fails after the SLA operation results in an ICMP echo failure three times.
B. The tracking return code fails after the SLA operation results in an ICMP echo failure one time.
C. After the tracking object fails, the tracking o bject moves back to an up state 45 seconds later in all cases.
D. After moving to a down state, the tracking object moves back to an OK state 45 seconds after the SLA operation moves to an OK state.
The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?（）
ip sla
1
icmp - echo 1.1.1.1 source -ip 2.2.2.2
ip sla schedule 1 start - time now life forever
A. The SLA operation will be configured but will not start until additional commands are used
B. The SLA operation is not comp letely configured so it will not collect any datA
C. The SLA operation is complete and working, collecting data into the RTTMON MIB
D. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration
A. ICMP Echo
B. VoIP (RTP)
C. IPX
D. SNMP
The following output occurs on Router R2. Which of the following statements can be confirmed as true based on the output from R2?（）
R2# show ip policy
Interface Route map
Fa0/0 RM1
Fa0/1 RM2
S0/0/0 RM3
A. R2 will forward all packets that enter Fa0/0 per the PBR configuration.
B. R2 will use route map RM2 when determining how to forward packets that exit interface Fa0/1.
C. R2 will consider using PBR for all packets exiting S0/0 /0 per route map RM3.
D. R2 will consider using PBR for all packets entering S0/0/0 per route map RM3.
Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What will Router R1 do with the packets generated by host 172.16.3.3 because of the telnet,assuming the packets enter R1's F0/0 interface?（）
interface Fastethernet 0/0
ip address 172.16.1.1 255.255.255.0
ip policy route - map Q2
!
route - map Q2 permit
match ip address 101
set interface s0/0/1
!
access - list 101 permit tcp host 172.16.3.3 172.16.4.0 0.0.0.255
A. The packet will be forwarded out S0/0 /1, or not at all.
B. The packet will be forwarded out S0/0/1 if it is up.
C. The packet will be forwarded out S0/1/1 if it is up.
D. The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E. The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
A. Packets entering F0/0 will be compared based on the PBR route map.
B. Packets exiting F0/0 will be compared based on the PBR route map.
C. IOS ignores the PBR forwarding directions wh en the packet matches a route map deny clause.
D. IOS ignores the PBR forwarding directions when the packet matches a route map permit clause.
最新試題
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
An engineer is trying to summarize the following networks using the "ip summary- address eigrp"command:10.8.88.0/2510.8.89.48/2910.8.64.96/27Which network and subnet mask below would be the smallest EIGRP summary address to include all three subnets?（）
Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.Which of the following is most likely to be useful on the branch router?（）
Which of the following are true of both OSPFv2 and OSPFv3?（）
Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?（）
Which of the following answers lists either a protocol or function that can be used by a host to dynamically learn its own IPv6 address?（）
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?（）
Look at the following configuration below and select the statements that are true.（）RD2(config)#router ospf 100RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - meRD2(config -router)#!RD2(config - router) #ip access - list standard match - meRD2(config - std - nacl)# permit host 172.16.0.0
Router R1 use s MAC address 1111.1111.1111 for its Fa0/0 interface. An engineer sees the following configuration in the output of a show running - config command. Then, the engineer issues a show ipv6 interface brief command. What global unicast IPv6 address does this c ommand display for interface tunnel 1?（）interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 1tunnel source loopback 1tunnel destination 192.168.1.2tunnel mode ipv6ip isatapipv6 address 2000::/64 eui - 64
Which of the following must match for two directly connected routers running OSPF to establish a neighbor adjacency?（）