Refer to the exhibit.
Which statement is true when voice traffic is forwarded on the same VLAN used by the data traffic? ()
A.The voice traffic cannot be forwarded to the distribution layer.
B.The voice traffic cannot use 802.1p priority tagging.
C.Port security cannot be enabled on the switch that is attached to the IP phone.
D.Quality of service cannot be applied for the voice traffic.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
Why does the trust state of interface FastEthernet 0/3 show "not trusted"? ()
A.DSCP map needs to be configured for VOIP.
B.ToS has not been configured.
C.ToS has been misconfigured.
D.The command mls qos needs to be turned on in global configuration mode.
E.There is not a Cisco Phone attached to the interface.
Refer to the exhibit.
What statement is true about the configuration on switch CAT1?()
A.The configuration establishes policed DSCP on ports Fa0/11 and Fa0/12 with values ranging from 8 to 56.
B.The configuration overrides 802.1p priorities on packets entering ports Fa0/11 and Fa0/12 with a value of 48.
C.Untagged Port VLAN ID (PVID) frames will carry voice traffic on VLAN 40.
D.Two IP phones with the MAC addresses of 0008.8595.d1a7 and 0007.8595.d2b7 are connected to CAT1 ports Fa0/11 and Fa0/12, respectively.
E.Security violation shutdown mode has been activated for ports Fa0/11 and Fa0/12.
F.The configuration overrides the Quality of Service value in packets entering ports Fa0/11 and Fa0/12 with a value of 45.
You need to configure a new Cisco router to be installed in the Company VOIP network.
Which three interface commands will configure the switch port to support a connected Cisco phone and to trust the CoS values received on the port if CDP discovers that a Cisco phone is attached? ()
A.switchport voice vlan vlan-id
B.mls qos trust device cisco-phone
C.switchport priority extend cos_value
D.mls qos trust cos
E.mls qos trust override cos
Refer to the exhibit.
Which three statements are true about trust boundaries in the campus network?()
A.Classification and markingoccur using 802.1ab QoS bits before reaching the trust boundary.
B.A device is trusted if it correctly declassifies packets.
C.A device is trusted if it correctly classifies packets.
D.Network trust boundaries are automatically configured in IOS version 12.3 and later.
E.The outermost trusted devices represent the trust boundary.
F.For scalability, classification should be done as close to the edge as possible.
Refer to the exhibit.
Which two statements are true about the required switch configurations to support a voice VLAN?()
A.CDP must be disabled on the switch port to prevent interference between CDP messages and voice traffic.
B.Port security cannot be configured on a port that is configured for a voice vlan.
C.Static secure MAC addresses should be configured on voice vlan ports to prevent access by devices other than IP phones.
D.CDP must be enabled on the switch port to allow configuration information to be passed to the IP phone.
E.Portfast must be enabled on the switch port.
F.802.1x authentication cannot be configured on a port configured for a voice vlan.
You have been tasked with setting a trust boundary on the Company network.
What is the basic function of this trust boundary?()
A. Trust boundaries are points in the network where Layer 2 CoS markings are converted to Layer 3 DSCP or IP precedence markings.
B. Trust boundaries are a point in the network where QoS functionality begins and ends.
C. Trust boundaries determine whether certain types of traffic can pass.
D. Trust boundaries are a point in the network where decisions about CoS markings on incoming packets are made.
E. None of the other alternatives apply
Refer to the exhibit. On basis of the configuration that is provided,
where will the trust boundary be established in this network? ()
A.at the PC
B.at the access switch
C.at the IP phone
D.at the distribution switch
You need to determine where the trust boundaries will be in a new Company VOIP design.
Which two statements are true about these trust boundaries?()
A.Trust boundaries are configured in the core of the network to provide the most efficient forwarding based upon QoS markings,
B.Setting trust boundaries at the edge of the network allows intermediate hop devices to administer QoS policies without detailed packet identification.
C.Trust boundaries are used to determine which QoS mechanism will be applied to the traffic.
D.At the trust boundaries, the untrusted traffic will be marked with a new QoS value appropriate for the policy in place at the point where the traffic entered the campus network.
E.Trust boundaries define the firewall rules for QoS admission into a network.
Refer to the exhibit. Based upon the information that is given,
how will voice traffic from the phone and data traffic from the PC be handled by SW_1? ()
A.The switch port will perform marking for the ingress voice and data traffic by using the defaultCoS value at the switch port.
B.The switch port will trust theCoS value of the ingress voice and data traffic that comes into the switch port.
C.The switch port will trust theCoS value of the ingress voice traffic. Data traffic will be marked at the switch port with the default CoS value.
D.The switch port will trust theCoS value of the ingress data traffic. Voice traffic will be marked at the switch port with the default CoS value.
The voice VLAN feature has been enabled on a new Company Catalyst switch port.
What is the effect of this? ()
A.The CoS is trusted for 802.1P or 802.1Q tagged traffic.
B.PortFast is disabled on the port.
C.Port Security is automatically enabled on a voice VLAN port.
D.Untagged traffic is sent according to the default CoS priority of the port.
E.None of the other alternatives apply
最新試題
Refer to the exhibit. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link?()
Which statement is correct about the use of the virtual interface on a WLC ?()
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?()
During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1? ()