Refer to the exhibit. What two statements are true?()
A. This is the designated router (DR) on the FastEthernet 0/0 link.
B. The output was generated by the show ip interface c ommand.
C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1
D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.
E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.
F. OSPF version 2 has been enabled to support IPv6.
您可能感興趣的試卷
你可能感興趣的試題
A. 2001:0DB8:417A
B. 2001::0DB8::417A
C. 2001:::0DB8::417A
D. 2001:0D B8:0:0:417A
E. 2001::DB8:0:0:417A
F. 2001:::0DB8:0:0:417A
A. An IPv6 address is 128 bits long.
B. An IPv6 header contains the header checksum field.
C. An IPv6 header is 20 bits long.
D. An IPv6 header contains the next header field.
E. IPv6 route rs send RA messages.
F. An IPv6 header contains the protocol field.
A. OSPFv3 for IPv6 authen tication is supported by IPv6 IPsec.
B. OSPFv3 for IPv6 authentication is supported by MD5 authentication.
C. OSPFv3 for IPv6 authentication is supported by IPv4 IPsec.
D. OSPFv3 for IPv6 authentication is supported by SHA - 1 authentication.
A. ::/0 is the default route, and ::/128 is the unspecified address.
B. ::/0 is the unicast address, and ::/128 is the anycast address.
C. ::/0 is the anycast address, and ::/128 is the multicast address.
D. ::/0 is the unicast address, and ::/12 8 is the multicast address.
E. ::/0 is the unspecified address, and ::/128 is the multicast address.
F. ::/0 is the anycast address, and ::/128 is the default address.
A. Every 16 - bit segment segment that consists of all zeroes can be represented with a single colon.
B. The trailing zeroes in any 16 - bit segment do not have to be written.
C. The leading zeroes in any 16 - bit segment do not have to be written.
D. Any single, continuous string of one or more 16 - bit segments that consists of all zeroes can be represented with a double colon.
E. The maximum number of times a double colon can replace a 16 - bit segment that consists of all zeroes is two.
F. Two zeroes in the middle of any 16 -bit segment do not have to be written.
A. The network was originated via redistribution of an interior gateway protocol into BGP.
B. The network was defined by a static route.
C. The network was learned via IBGP.
D. The network was learned via EBGP.
E. The network was originated via a network or aggregate command.
A. Within an AS, all routers must run either BGP or IBGP.
B. An AS uses exterior gatew ay protocols (EGPs) to exchange information with other autonomous systems.
C. An AS is a group of routers under the same technical administration.
D. Within an AS, routes learned through BGP can be redistributed using interior gateway protocols.
E. Wi thin an AS, routes learned through an interior protocol cannot be redistributed using BGP to other autonomous systems.
A. The IBGP neighbor is not directly connected.
B. BGP synchronization is enabled in a transit autonomous system with fully - meshed IBGP neighbors.
C. The EBGP neighbor ebgp - multihop option is set to the de fault value.
D. The BGP update interval is different between the two BGP neighbors.
E. The BGP neighbor is referencing an incorrect autonomous system number in its neighbor statement.
F. There is an access list blocking all TCP traffic between the two BGP neighbors.
A. show ip bgp paths
B. show ip bgp peers
C. show ip bgp
D. show ip bgp summary
A. local preference
B. MED
C. weight
D. or igin
E. next - hop
F. AS - path
最新試題
Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?()
An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?()
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?()ipv6 router ospf 1ipv6 unicast- routinginterface f0/0ipv6 address 2000 ::1/64ipv6 ospf 1 area 1interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 ospf 1 area 0
Which of the following answers lists a multicast IPv6 address?()
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?()ipv6 unicast- routinginterface f0/0ipv6 rip one enableipv6 address 2000::1/64interface s0/0/0ipv6 address 2001::/64 eui - 64ipv6 rip one enable
Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise.Which of the following is most likely to be useful on the branch router?()
The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer?()interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 2ipv6 address 2002:C0A8:10 1::1/64tunnel source loopback 1
Which of the following features work the same in both RIP- 2 and RIPng?()
Which of the following are true of both OSPFv2 and OSPFv3?()
Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, and into the core of an Enterprise network. The branch also allows local hosts to communicate directly with public sites in th e Internet over this same DSL connection.Which of the following answers defines how the branch NAT config avoids performing NAT for the Enterprise directed traffic but does perform NAT for the Internet - directed traffic?()