LDAP is being used throughout the Company wireless network.
Which statement about the Lightweight Access Point Protocol （LWAPP） protocol is true？（）
A. The processing of 802.11 data and management protocols and access point capabilities is distributed between a lightweight access point and a centralized WLAN controller.
B. LWAPP advertises its WDS capability and participates in electing the best WDS device for the wireless LAN.
C. LWAPP aggregates radio management forward information and sends it to a wireless LAN solution engine.
D. LWAPP authenticates all access points in the subnet and establishes a secure communication channel with each of them.
E. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Both host stations are part of the same subnet but are in different VLANs. On the basis of the information presented in the exhibit，
which statement is true about an attempt to ping from host to host？ （）
A. The two different hosts will need to be in the same VLAN in order for the ping command to be successful.
B. A Layer 3 device is needed for the ping command to be successful.
C. The ping command will be successful without any further configuration changes.
D. A trunk port will need to be configured on the link between Sw_A and Sw_B for the ping command to be successful.
Based on the network diagram and routing table output in the exhibit，
which of these statements is true？ （）
A. InterVLAN routing will not occur since no routing protocol has been configured.
B. InterVLAN routing has been configured properly， and the workstations have connectivity to each other.
C. Although interVLAN routing is not enabled， both workstations will have connectivity to each other.
D. Although interVLAN routing is enabled， the workstations will not have connectivity to each other.
Refer to the exhibit. VLAN2， VLAN3， and VLAN10 are configured on the switch D-SW1. Host computers are on VLAN 2 （10.1.2.0）， servers are on VLAN 3 （10.1.3.0）， and the management VLAN is on VLAN10 （10.1.10.0）. Hosts are able to ping each other but are unable to reach the servers. On the basis of the exhibited output，
which configuration solution could rectify the problem？（）
A. Assign an IP address of 10.1.3.1/24 to VLAN3.
B. Configure default gateways to IP address 10.1.10.1 on each host.
C. Enable IP routing on the switch D-SW1.
D. Configure a default route that points toward network 200.1.1.0/24.
E. Configure default gateways to IP address 10.1.2.1 on each host.
F. Configure default gateways to IP address 200.1.1.2 on each host.
Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have been assigned to their respective VLANs. The rest of the 3550 configuration is the default configuration. Host A is able to ping its default gateway， 10.10.10.1， but is unable to ping Host B. Given the output displayed in the exhibit，
which statement is true？ （）
A. A separate router is required to support interVLAN routing.
B. VTP must be configured to support interVLAN routing.
C. VLANs 10 and 15 must be created in the VLAN database mode.
D. The global config command ip routing must be configured on the SW1 switch.
E. HSRP must be configured on SW1.
F. Interface VLAN 10 must be configured on the SW1 switch.
Refer to the exhibit. Dynamic ARP inspection （DAI） is enabled on switch SW_A only. Both Host_A and Host_B acquire their IP addresses from the DHCP server connected to switch SW_A.
What would the outcome be if Host_B initiated an ARP spoof attack toward Host_A ？ （）
A. The spoof packets will be inspected at the ingress port of switch SW_A and will be permitted.
B. The spoof packets will not be inspected at the ingress port of switch SW_A and will be permitted.
C. The spoof packets will not be inspected at the ingress port of switch SW_A and will be dropped.
D. The spoof packets will be inspected at the ingress port of switch SW_A and will be dropped.
Refer to the exhibit.
What will happen to traffic within VLAN 14 with a source address of 172.16.10.5？ （）
A. The traffic will be forwarded to the router processor for further processing.
B. The traffic will be dropped.
C. The traffic will be forwarded to the TCAM for further processing.
D. The traffic will be forwarded without further processing.
A hacker on the Company network is attempting to hop onto a different VLAN.
Which two statements about VLAN hopping are true？ （）
A. An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the 802.1q encapsulation.
B. Configuring an interface with the "switchport mode dynamic" command will prevent VLAN hopping.
C. Attacks are prevented by utilizing the port-security feature.
D. Configuring an interface with the "switchport mode access" command will prevent VLAN hopping.
E. An end station attempts to redirect VLAN traffic by broadcasting multiple ARP requests.
The Company security administrator wants to prevent VLAN hopping on the network.
What is one method that can be used to do this？ （）
A. Attacks are prevented by utilizing the port-security feature.
B. An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the 802.1q encapsulation.
C. Configuring an interface with the switchport mode dynamic command will prevent VLAN hopping.
D. An end station attempts to redirect VLAN traffic by transmitting Ethernet frames in the 802.1q encapsulation.
E. Configuring an interface with the "switchport mode access" command will prevent VLAN hopping.
The Company security administrator is concerned with VLAN hopping based attacks.
Which two statements about these attacks are true？ （）
A. Attacks are prevented by utilizing the port-security feature.
B. An end station attempts to gain access to all VLANs by transmitting Ethernet frames in the 802.1q encapsulation.
C. Configuring an interface with the switchport mode dynamic command will prevent VLAN hopping.
D. An end station attempts to redirect VLAN traffic by transmitting Ethernet frames in the 802.1q encapsulation.
E. Configuring an interface with the "switchport mode access" command will prevent VLAN hopping.
Refer to the exhibit. PCs in VLAN 2 are not able to communicate with PCs in VLAN 3.
What could be the cause？（）
A. IP routing is not enabled.
B. VTP is not configured correctly on the interfaces.
C. The command mls rp management-interface is missing.
D. The command mls rp ip must be disabled to enable the routing.
最新試題
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Refer to the exhibit. For what purpose is the command show ip cef used？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Which statement is correct about RSTP port roles？（）
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）