Which of the following could be used to provide a Layer 3 data path between separate VLANs?()
A. VLAN trunking
B. An external router
C. An internal route processor
D. VLAN capable bridge
E. EtherChannel
您可能感興趣的試卷
你可能感興趣的試題
Inter-VLAN routing has been implemented in the Company network. In VLAN routing,
what are some of the disadvantages of designing a router-on-stick configuration? ()
A. InterVLAN routing cannot be filtered by the router.
B. The router becomes a single point of failure for the network.
C. Routers will not route STP BPDUs.
D. There is a possibility of inadequate bandwidth for each VLAN.
E. Additional overhead on the router can occur.
F. NetFlow Switching is required for InterVLAN accounting.
The Company network needs to pass traffic between VLANs.
Which device should be used to accomplish this? ()
A. Hub
B. Switch
C. Router
D. Bridge
E. None of the other alternatives apply
pany has implemented numerous multilayer switches that utilize FIB tables.
Which statement is true about the Forward Information Base (FIB) table?()
A. The FIB is derived from the IP routing table and is optimized for maximum lookup throughput.
B. The FIB table is derived from the Address Resolution Protocol table, and it contains Layer 2 rewrite (MAC) information for the next hop.
C. When the FIB table is full, a wildcard entry redirects traffic to the Layer 3 engine.
D. The FIB lookup is based on the Layer 2 destination MAC address.
E. None of the other alternatives apply
Refer to the exhibit.
What type of attack is being defended against? ()
A. snooping attack
B. rogue device attack
C. STP attack
D. VLAN attack
E. spoofing attack
F. MAC flooding attack
Refer to the exhibit.
What will happen to traffic within VLAN 14 with a source address of 172.16.10.5?()
A. The traffic will be forwarded to the router processor for further processing.
B. The traffic will be dropped.
C. The traffic will be forwarded to the TCAM for further processing.
D. The traffic will be forwarded without further processing.
Refer to the exhibit.
What will happen when one more user is connected to interface FastEthernet 5/1?()
A. The first address learned on the port will be removed from the secure address list and be replaced with the new address.
B. All secure addresses will age out and be removed from the secure address list. This will cause the security violation counter to increment.
C. The packets with the new source addresses will be dropped until a sufficient number of secure MAC addresses are removed from the secure address list.
D. The interface will be placed into the error-disabled state immediately, and an SNMP trap notification will be sent.
Refer to the exhibit. The show port-security interface fa0/1 command was issued on switch SW1. Given the output that was generated,
which two security statement are true? ()
A. Interface FastEthernet 0/1 was configured with the switchport port-security aging command.
B. Interface FastEthernet 0/1 was configured with the switchport port-security protect command.
C. Interface FastEthernet 0/1 was configured with the switchport port-security violation restrict command.
D. When the number of secure IP addresses reaches 10, the interface will immediately shut down.
E. When the number of secure MAC addresses reaches 10, the interface will immediately shut down and an SNMP trap notification will be sent.
Switch R1 has been configured with Private VLANs.
With that type of PVLAN port should the default gateway be configured?()
A. Trunk
B. Isolated
C. Primary
D. Community
E. Promiscuous
F. None of the other alternatives apply
What is true about access control on bridged and routed VLAN traffic? ()
A. Router ACLs can be applied to the input and output directions of a VLAN interface.
B. Bridged ACLs can be applied to the input and output directions of a VLAN interface.
C. Only router ACLs can be applied to a VLAN interface.
D. VLAN maps and router ACLs can be used in combination.
E. VLAN maps can be applied to a VLAN interface
On a Company switch named R1 you configure the following: iparp inspection vlan 10-12, 15
What is the purpose of this global configuration command made on R1?()
A. Discards ARP packets with invalid IP-to-MAC address bindings on trusted ports
B. Validates outgoing ARP requests for interfaces configured on VLAN 10, 11, 12, or 15
C. Intercepts, logs, and discards ARP packets with invalid IP-to-MAC address bindings
D. Intercepts all ARP requests and responses on trusted ports
E. None of the other alternatives apply
最新試題
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()
Which three statements are true of the Link Aggregation Control Protocol (LACP)?()
How are STP timers and state transitions affected when a topology change occurs in an STP environment?()
Which two statements are true when the extended system ID feature is enabled? ()
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()
Which statement is correct about the use of the virtual interface on a WLC ?()
Refer to the exhibit. What does the command channel-group 1 mode desirable do? ()
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()