A. Before they are routed to an outbound interface.
B. After they are routed for outbound traffic.
C. After they are routed to an outbound interface while queuing.
D. Before and after they are routed to an outbound interface.
E. Depends on the configuration of the interface
F. None of the above
您可能感興趣的試卷
你可能感興趣的試題
A. To configure a route to the first Layer 3 device on the network segment.
B. To configure a route from an ISP router into a corporate network.
C. To configure a route when the administrative distance of the current routing protocolis too low.
D. To reach a network is more than 15 hops away.
E. To provide access to the Internet for enterprise hosts.
A. router(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1
B. router(config)# ip default-route 10.1.1.0
C. router(config)# ip default-gateway 10.1.1.0
D. router(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
A.
B.
C.
D.
E.
F.
A. It is globally enabled by default on Cisco routers.
B. It is globally enabled by default on all routers.
C. It is a proprietary protocol.
D. It is a non-proprietary protocol.
E. It can be used to gather hardware and protocol information about neighbor devices.
A. The Frame Relay encapsulation on the physical interface.
B. The local DLCI on each subinterface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point.
A.close
B.disable
C.disconnect
D.suspend
E.exit
F.None of the above
The Testking Network consists of the following 5 IP networks:
NETWORK 1: 192.168.10.0/26
NETWORK 2: 192.168.10.64/27
NETWORK 3: 192.168.10.96/27
NETWORK 4: 192.168.10.128/30
NETWORK 5: 192.168.10.132/30
Which of the following routing protocols will support this IP addressing scheme?（）
A. RIP version 1
B. RIP version 2
C. IGRP
D. EIGRP
E. OSPF
F. BGP
A. CIDR
B. Split horizon
C. Authentication
D. Classless masking
E. Hold-down timers
F. Multicast routing updates
G. Path Vectoring
You need to implement the use of a routing protocol that meets the following
requirements:
1. Converges quickly
2. Supports VLSM, CIDR, IP, and IPX.
3. Uses minimal bandwidth for routing updates.
Which one of the following routing protocols would be the best choice?（）
A. RIPv1
B. RIPv2
C. IGRP
D. OSPF
E. EIGRP
A. RIPv1
B. IGRP
C. EIGRP
D. OSPF
E. IS-IS
F. RIPv2
最新試題
What is a global command?（）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）
Which of the following options lists the steps in PPP session establishment in the correct order?（）
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? （）
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? （）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）