A.clear nat translations
B.clear ip nat translations*
C.clear ip nat statistics
D.clear ip nat transactions*
E.clear ip nat translations
F.clear ip nat translations all
您可能感興趣的試卷
你可能感興趣的試題
A.EIGRP advertises the best routes to its neighbor
B.EIGRP uses "cost" to determine best path
C.EIGRP allows unequal cost load balancing
D.OSPF requires neighbor adjacencies before updates are sent
E.EIGRP advertises all routes to its neighbor
F.OSPF allows unequal cost load balancing
A.Predictable security vulnerabilities
B.Economies of scale
C.Improved expenditure forecasts
D.Increased downtime
E.Predictable equipment obsolescence
F.Consumption of fewer resources
A.With IGMPvl, queries are sent to a specific group
B.Hosts issuing IGMPvl requests will be correctly interpreted by IGMPv2 hosts due to backwardcompatibility
C.An IGMPv2 router will ignore IGMPv2 leave messages when IGMFVl hosts are present
D.With IGMFV2, a leave message is supported
E.An IGMPv2 host will send an IGMFVl report on an IGMFVl router
F.An IGMPv2 router can only allow IGMPv2 hosts to execute a join request
A.Layer 1 status
B.Output queue drops
C.Interface CPU utilization
D.Cable type connected to interface
E.Layer 2 status
F.Input queue drops
A.show crypto map ipsec sa
B.show crypto map
C.show crypto engine connections active
D.show ipsec crypto map
E.show crypto map sa
F.show ipsec crypto map sa
A.Fast switching reducesa routers CPU utilization, compared to process switching
B.All packets of a flow, except for the first packet, use the information in the fast cache
C.It can be enabled with the interface command ip route-cache
D.Fast switching uses a fast cache maintained in a router’s control plane
E.The fast cache contains information about how traffic from different data flows should beforwarded
F.Even though the fast switching is enabled, the first packet of a flow is still process switched
A.configure archive running-config
B.configure replace
C.copy archive running config
D.copy startup-config running-config
E.copy tftp running-config
F.configure tftp running-config
A.Only when there is a duplicate IP address caused by a combination of static and dynamic IPaddress allocations
B.On each router that exists between the client and the server
C.Only when a router separates the client from the server
D.Only if the DHCP sever issues a DHCPNAK to the initial request
E.Only when the client is on the same subnet as the server
F.Only when the DHCP pool is out of IP addresses
A.The command will initiate a probe with a destination IP address of 10.1.1.1
B.The command is used on the IP SLA responder and the IP SLA source
C.The command will allow only source address 10.1.1.1 to source probes
D.The command will initiate a probe with a destination Telnet port
E.The command is used to make the router a responder
F.The command will initiate a probe with a source port of 23
A.Use the Cisco Auto Configuration tool
B.Use the Cisco Rollback feature
C.Automate documentation
D.Schedule documentation checks
E.Use the Cisco Configuration Archive tool
F.Require documentation prior to a ticket being closed out
最新試題
A new router was configured with the following commands:The configuration above was found on an Internet Service Provider’s (ISP) Multiprotocol LabelSwitching (MPLS) network. What is its purpose?()
Which three statements accurately describe IOS Firewall configurations?()
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Refer to the exhibit. Which two statements about the AAA configuration are true?()
Router NetworkTut is configured as shown below:Given the above configuration, which statement is true?()
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.(Not allstatements will be used)
cisco ios command to interface dialer 0
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed?()
Match the xDSL type on the above to the most appropriate implementation on the below.