Refer to the exhibit. Router RTA has been configured as a DHCP server for router RTC. On thebasis of the information that is provided， which statement about DHCP is true？（）
A.The VLAN1-POOL argument must be issued for the Fa0/1 interface on router RTA
B.Router RTA must be configured with the default-router 192.168.3.2 DHCP command.
C.The ip address dhcp interface configuration command must be issued for the Fa0/1 interface ofrouter RTA
D.The ip helper-address 192.168.1.2 interface configuration command must be issued for theFa0/1 interface on router RTA
E.Router RTC must be configured with the ip address dhcp global configuration command
F.The lease 200 DHCP configuration command would change the default DHCP lease time to48 hours on router RTA
您可能感興趣的試卷
你可能感興趣的試題
A.53（DNS）
B.69（TFTP）
C.515（LPR）
D.161（SNMP）
E.49（TACACS）
A.IP Helper is used to direct BOOTP clients to a BOOTP server
B.IP Helper is used to prevent the router form forwarding IP broadcasts
C.IP Helper is used to allow IPX clients to communicate with IP-based servers
D.IP Helper is used to accommodate compatibility routers using different IP routing protocols
E.None of the other alternatives apply
RIP and OSPF are configured on the routers as shown in the exhibit. R2 is configured with a two-way redistribution between RIP and OSPF domains. All routers can ping each other， but R1cannot see any of the OSPF routes in its routing table. What could the problem be？（）
A.OSPF and RIP use the same major network 172.16.0.0. Therefore， the keywordsubnets is notrequired to redistribute protocols into OSPF
B.Because OSPF has a longer mask for the same major network than RIP and because RIPversion 1 is being used， none of the routes learned from OSPF will be advertised into RIP
C.The metric for the OSPF routes that are redistributed into RIP is too low， a fact that preventsOSPF routes from being advertised into RIP
D.The process of redistribution of RIP into OSPF does not require any metric conversion， so thereis no need to define the metric using the default-metric command during the redistribution
Refer to the network shown below：
R1 and R2 belong to the RIP routing domain that includes the networks 10.20.0.0/16 and
10.21.0.0/16. R3 and R4 are performing two-way route redistribution between OSPF and RIP. Anetwork administrator has discovered that R2 is receiving OSPF routes for the networks
10.20.0.0/16 and 10.21.0.0/16 and a routing loop has occurred. Which action will correct thisproblem？（）
A.Set the OSPF default metric to 20
B.Apply an inbound ACL to the R2 serial interface
C.Configure distribute-lists on R3 and R4
D.Change the RIP administrative distance on R3 to 110
E.Change the OSPF administrative distance on R3 to 110
F.None of the other alternatives apply
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated inthe exhibit. Given the partial configuration of router R2， which network will be present in the routingtable of R4？（）
A.Network B
B.Network A and Network B
C.Network A
D.neither Network A nor Network B
Refer to the exhibit and the partial configuration on router R2. On router R4 all RIP routes areredistributed into the OSPF domain. A second redistribution is configured on router R2 using aroute map. Based on the configuration on router R2， which EIGRP external routes will be presentin the routing table of R1？（）
A.There will be no EIGRP external routes in the routing table of R1
B.The routes originating from the RIP routing domain
C.Only routes originating in the OSPF routing domain
D.All routes originating from RIP and OSPF routing domains
E.None of the other alternatives apply
A.00-00-0c-c0-05-0a
B.00-00-0c-cl-05-0a
C.01-00-5e-00-00-0c
D.01-00-5e-41-05-0a
E.00-00-0c-01-00-5e
F.01-00-5e-cl-05-0a
A.Incorrect distribute lists have been configured
B.Missing ip classless command
C.CEF not enabled
D.No default metric configured for EIGRP
Refer to the exhibit. Which two statements are correct？（）
A.All the routes were redistributed into BGP from an IGP
B.All the routes were originated by BGP with the network command
C.All six routes will be installed in the routing table
D.Four routes will be installed in the routing table
E.Two routes will be installed in the routing table
Refer to the exhibit. BGP has been configured on the routers in the network. However， the IBGPpeers in autonomous system 65200 have not converged. In addition， this console message wasgenerated on router R2：
*Mar 1 03：09：07.729： %TCP-6-BADAUTH No MD5 digest from 10.10.23.2（179） to10.10.23.3（11002）
On the basis of the information that is provided， what is the cause of the problem？（）
A.OSPF must be configured with the same MD5 authentication
B.BGP authentication can be used on iBGP peers when the connection is configured between theloopback interfaces
C.BGP authentication can be used on eBGP peers only
D.The password that is used for BGP authentication on both BGP peers in autonomous system65200 must be the same
最新試題
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag the DSL local loop topic on the left to the correct descriptions on the right.
cisco ios command to interface dialer 0
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）