A. secure tunnels
B. a separate management VLAN
C. secure VLANs to isolate sensors
D. an out-of-band path around the firewall
E. asymmetric traffic flows to isolate sensors
F. private VLANs to put all sensors on isolated ports
您可能感興趣的試卷
你可能感興趣的試題
A. bridging VLANs on two switches
B. bridging two VLANs on one switch
C. between two Layer 2 devices withtrunking
D. between two Layer 2 devices withouttrunking
E. between a Layer 2 device and a Layer 3 device withtrunking
A. only operational in routed mode
B. only operational in transparent mode
C. only eight interfaces can belong to an asymmetric routing group
D. operational in both failover and non-failover configurations
E. only operational when the firewall has been configured for failover
A. The FWSM supports up to 16 asymmetric routing groups.
B. If a matching packet is not found, the packet is dropped.
C. Asymetric routing of return traffic is enabled.
D. If a matching packet is found, the Layer 3 header is rewritten.
E. If a matching packet is found, the Layer 3 header is rewritten and the packet is forwarded to the default gateway.
A. Transparent mode is layer 2.
B. Routed mode is layer 3.
C. Routed mode has 1 IP address.
D. Transparent mode has 1 IP address.
A.routed mode
B.context mode
C.bridged mode
D.transparent mode
E.full security mode
A. It helps verify end-to-end path availability.
B. It provides traffic rerouting in case of disaster.
C. HSRP, GLBP, and VRRP can be clients of GSS.
D. BGP must be the routing protocol between the distributed data centers.
E. DNS responsiveness is improved by providing centralized domain management.
A. It can take on HSRP, VRRP, and GLBP as clients.
B. It provides automatic inbound route optimization.
C. Path selection may be based on delay, loss, or jitter.
D. The border router makes decisions about which outbound path to use.
E. Automatic load distribution is provided for multiple connections.
A. The design supports multiple server subnets.
B. An end-user sees the IP address of the real server.
C. SLB routes between the outside and inside subnets.
D. The source or destination MAC address is rewritten, but the IP addresses left alone.
E. SLB acts as a "bump in the wire" between servers and upstream firewall or Layer 3 devices.
Refer to the exhibit. Which two of these are characteristics of a firewall running in transparent mode?()
A. FWSM routes traffic between the VLANs.
B. FWSM switches traffic between the VLANs.
C. Transparent mode is often called bump-in-the-wire mode.
D. Transparent mode firewall deployments are used most often in current designs.
E. Traffic routed between VLANs is subject to state tracking and other firewall configurable options.
A. Zoning increases security.
B. DNS queries are used for software zoning.
C. Software zoning is more secure than hardware zoning.
D. When using zones and VSANs together, the zone is created first.
E. Zoning requires that VSANs be established before it becomes operational.
最新試題
During consultation, you find that a customer has only a single asset closet and is looking for a solution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer?()
What will an Easy VPN hardware client require in order to insert its protected network address when it connects using network extension mode?()
As an experienced technician, you are responsible for infrastructure design and global configuration changes. You are asked to deploy a Voice over Wireless LAN for your company. If the cells have the same channel, the separation between them should be:()
Which of these statements is true of routing protocols in a hub-and-spoke IPsec VPN topology?()
Cisco Express Forwarding (CEF) is mainly used to increase packet switching speed, reducing the overhead and delays introduced by other routing techniques, increasing overall performance.Which of the following concerning CEF is recommended by Cisco?()
Which three of these are important when determining NAS Server scaling? ()
You are the Cisco Network Designer . Which is not major scaling, sizing, and performance consideration for an IPsec design?()
In which NAS operating mode are ACL filtering and bandwidth throttling only provided during posture assessment?()
What amount of cell overlap ensures smooth roaming for wireless endpoints?()
As an experienced technician, you are responsible for Technical Support. Which of the following descriptions is correct about the characteristic of SLB one arm mode?()