A network administrator is troubleshooting an EIGRP connection between RouterA， IP address10.1.2.1， and RouterB， IP address 10.1.2.2. Given the debug output on RouterA， which twostatements are true？（）
A.RouterA received a hello packet with mismatched metric-calculation mechanisms
B.RouterA received a hello packet with mismatched authentication parameters
C.RouterA will form an adjacency with RouterB
D.RouterA received a hello packet with mismatched autonomous system numbers
E.RouterA received a hello packet with mismatched hello timers
F.RouterA will not form an adjacency with RouterB
您可能感興趣的試卷
你可能感興趣的試題
The following command was issued on Router 2：
Given the above output shown above， which statement is true？（）
A.192.168.1.0 is a redistributed route into EIGRP
B.192.168.1.0 is a summarized route
C.192.168.1.0 is a static route
D.192.168.1.0 is equal path load balancing with 172.16.1.0
E.None of the other alternatives apply
The EIGRP network is displayed in the following topology diagram：
You work as a network technician. Study the exhibits carefully. If the command "variance 3" wasadded to the EIGRP configuration of R5， which path or paths would be chosen to route traffic fromR5 to network X？（）
A.R5-R2-R1
B.R5-R2-R1 and R5-R3-R1
C.R5-R3-R1 and R5-R4-R1
D.R5-R2-R1，R5-R3-R1， and R5-R4-R1
A.Use the service-policy command to adjust the QOS policy to allow the route to propagate.
B.Clear the BGP session.
C.Use the release BGP routing command.
D.Change both the inbound and outbound policy related to this route.
E.None of the other alternatives apply
The network is shown below， along with the relevant router configurations：
With the topology found in the graphic， what will the R1 loopback 0 be in the R3 routing table？（）
A.It will show up in the routing table as D 10.0.0/8
B.It will show up in the routing table as D EX 10.0.0.0/8
C.It will show up in the routing table as D 10.0.0./24
D.It will not show up in R3 routing table because there is no network command on R1
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
A.The 172.16.1.1 neighbor is down.
B.The prefix 10.10.10.0/24is not a’connected’route.
C.This route is not a BGP learned route.
D.The network command is wrong.
E.None of the other alternatives apply
A.The neighboring router stops receiving ACK packets from this router
B.The neighboring router starts receiving route updates from this router
C.The neighboring router is too busy to answer the query （generally caused by high CPUutilization）
D.The neighboring router is having memory problems and cannot allocate the memory to processthe query or build the reply packet
A、The first 23 bits of the multicast MAC address are 0x01-00-5E. This is a reserved value thatindicates a multicast application
B、The last 3 bytes （24 bits） of the multicast MAC address are 0x01-00-5E. This is a reservedvalue that indicates a multicast application
C、To calculate the Layer 2 multicast address， the host maps the last 23 bits of the IP address intothe last 24 bits of the MAC address. The high-order bit is set to 0
D、The first 3 bytes （24 bits） of the multicast MAC address are 0x01-00-5E. This is a reservedvalue that indicates a multicast application
A.show ip ospf
B.show ip route
C.show ip protocols
D.show ip ospf database
E.None of the other alternatives apply
最新試題
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
Which statement about PPPoA configuration is correct？（）
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.