A. Troubleshooting is more complicated.
B. Service and switch modules are underutilized.
C. Layer 2 adjacency is required with the servers that use this design.
D. Layer 3 adjacency is required with the servers that use this design.
E. Load balancing will always occur across both access layer uplinks.
您可能感興趣的試卷
你可能感興趣的試題
A. Summarize data center subnets.
B. Use passive interfaces to ensure appropriate adjacencies.
C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D. Adjust the default bandwidth value to ensure proper bandwidth on all links.
E. Advertise a default summary route into the data center core from the aggregation layer.
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence.
A. Server-to-server traffic always remains in the core layer.
B. The recommended practice is for the core infrastructure to be in Layer 3.
C. The boundary between Layer 2 and Layer 3 should be implemented in the aggregation layer.
D. The Cisco Express Forwarding hashing algorithm is the default, based on the IP address and Layer 4 port.
E. Core layer should run BGP along with an IGP becauseiBGP has a lower administrative distance than any IGP.
A.ASM
B.BiDirPIM
C.PIM-SMRP
D.RP-Switchover
E.SourceSpecificMulticast
A. 0
B. 1
C. 2
D. 4
E. 16
F. infinity
A. a single host
B. a subset of hosts
C. all hosts sequentially
D. all hosts simultaneously
A.TCP502
B.TCP514
C.TCP520
D.UDP502
E.UDP514
F.UDP520
A. supports multiple MIBs
B. includesNetFlow, NBAR, and IP SLA software subsystems
C. includesNetFlow, syslog, and IP SLA software subsystems
D. includes a predefined framework for filtering and correlating messages
E. supports two logging processes so output can be sent in standard and ESM format
A. to provide service internetworking
B. to support transparency for Layer 2 frames
C. as a connection identifier to indicate destination
D. as a mapping to the DLCI in service internetworking
E. to provide a trunk by which all VLANs can navigate from one site to one or multiple sites
A. use BGP as the CE-PE routing protocol
B. use OSPF as the CE-PE routing protocol
C. use EIGRP as the CE-PE routing protocol
D. use the SP to redistribute routes as external routes for OSPF and EIGRP
E. use route redistribution at each location to ensure external routes are imported into the IGP
最新試題
The Cisco NAC Appliance is able to check which three items before allowing network access?()
As an experienced technician, you are responsible for Technical Support. One of the trainees is asking your advice on VPN Termination Device and Firewall Placement. Which of the following approaches will you recommend?()
Which of the following is the primary consideration to scale VPNs?()
Please match the Cisco STP enahancement term to its definition.()(1) BPDU guard(2) PortFast(3) BackboneFast(4) Loop guard(5) Root guard(a) shuts down a port that receives a BPDU when enabled(b) cuts convergence time by mas-age for indirect failure(c) prevents the aliernate or root port from being designated in absence of BPDUs(d )causes Layer 2 LAN interface access port to immediately enter the forwarding state(e) helps prevent bridging loops due to jni-directional link failures on point-to-point links
During consultation, you find that a customer has multiple asset closets and will be adding more in the future. Which NAS physical deployment model would you suggest to this customer?()
Refer to the exhibit. Which two statements about the topologies shown are correct?()
How many channels are defined in the IEEE 802.11b DSSS channel set?()
Client traffic is being bridged through LAN interfaces on two WLCs. Which roaming option will keep them on the same IP subnet?()
One of your customers has deployed a Layer 3 gateway in the untrusted network. Which gateway mode is appropriate for this customer?()
During consultation, you find that a customer has only a single asset closet and is looking for a solution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer?()