A.passively listens to network traffic
B.is an active device in the traffic path
C.has a permissive interface that is used to monitor networks
D.traffic arrives on one IDS interface and exits on another
E.has a promiscuous interface that is used to monitor the network
您可能感興趣的試卷
你可能感興趣的試題
A. Employ path MTU discovery.
B. Set the MTU higher than 1500 bytes.
C. Turn off pre-fragmentation for IPSec.
D. Set the MTU value to 1400 bytes.
A.queuing
B.jitter
C.packet loss
D.digitized sampling
E.signal-to-noise ratio ratio
Refer to the exhibit. Which two of these are correct regarding the recommended practice for distribution layer design？（）
A.use a redundant link to the core
B.use a Layer 2 link between distribution switches
C.never use a redundant link to the core because of convergence issues
D.use a Layer 3 link between distribution switches with route summarization
E.use a Layer 3 link between distribution switches without route summarization
A. They do not receive unique IP addresses.
B. RADIUS or LDAP is required.
C. They are assigned addresses from the internal DHCP pool.
D. Their traffic appears to originate from the originating host network.
A.Delay should be no more than 10 ms.
B.Loss should be no more than1 percent.
C.Jitter should be less then 40 ms.
D.Managed bandwidth is strongly recommended for voice control traffic.
A.cell phones
B.remote access
C.mobility services
D.network management
E.network unification
F.network decentralization
A.DTP
B.RPR
C.SDH
D.CWDM
E.DWDM
A.FlexLinks
B.loop-free U
C.looped square
D.looped triangle
E.loop-free inverted U
A.0.01
B.0.1
C.1
D.2.5
A. activity audit
B. administration
C. policy establishment
D. technology implementation
最新試題
What is the recommended radius of a cell for a voice-ready wireless network?（）
Cisco Express Forwarding (CEF) is mainly used to increase packet switching speed, reducing the overhead and delays introduced by other routing techniques, increasing overall performance.Which of the following concerning CEF is recommended by Cisco?（）
What is the recommended practice when considering VPN termination and firewall placement?（）
As an experienced technician, you are responsible for Technical Support. A customer calls to ask the best signal level and noise level for cell phone. How to respond?（）
What will an Easy VPN hardware client require in order to insert its protected network address when it connects using network extension mode?（）
You are the Cisco Network Designer . Which is not major scaling, sizing, and performance consideration for an IPsec design?（）
Which two of these are advantages of placing the VPN device parallel to the firewall?（）
During consultation, you find that a customer has multiple asset closets and will be adding more in the future. Which NAS physical deployment model would you suggest to this customer?（）
During consultation, you find that a customer has only a single asset closet and is looking for a solution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer?（）
Please match the Cisco STP enahancement term to its definition.（）(1) BPDU guard(2) PortFast(3) BackboneFast(4) Loop guard(5) Root guard(a) shuts down a port that receives a BPDU when enabled(b) cuts convergence time by mas-age for indirect failure(c) prevents the aliernate or root port from being designated in absence of BPDUs(d )causes Layer 2 LAN interface access port to immediately enter the forwarding state(e) helps prevent bridging loops due to jni-directional link failures on point-to-point links