Refer to the exhibit. Which three options are available when the Cisco Wireless Control System （WCS） discovers rogue access points on the LAN？（）
A.The WCS sends new rouge access point notifications.
B.The WCS locates and monitors rouge access points until they are eliminated or acknowledged.
C.The WCS reconfigures the rouge access point with proper authentication credentials.
D.The WCS sends deauthenticate and disassociate messages to the rouge access point.
E.The WCS contains rouge access points by sending their clients deauthenticate and disassociate messages
F.The WCS sends deauthenticate and disassociate messages to all wireless clients on the network.
您可能感興趣的試卷
你可能感興趣的試題
A.Asynchronous Transfer Mode （ATM）
B.data-link switching （DLSw）
C.Route Processor Redundancy （RPR）
D.Frame Relay （FR）
E.Metro Ethernet
F.Multiprotocol Label Switching （MPLS）
A.the time required from receipt of the incoming frame， until the frame/packet has been queued for transmission
B.the time taken for a single packet to traverse the physical medium from one end to the other
C.the time taken to place a frame on the physical medium for transport
D.the time spent for a packet to reside in the output queue of a router
A.best-effort delivery
B.ingress committed rate （ICR）
C.shaping and policing
D.egress committed rate （ECR）
E.Integrated Services （IntServ）
F.differentiated services （DiffServ）
Refer to the exhibit. The auto discovery qos command was configured on this interface 24 hours prior to the above configuration. Which statement is true about the configuration?（）
A. An IP address is needed on interface seriall/2.
B.The auto discovery qos command should be configured on the subinterface
C.A generated AutoOoS policy has been applied to serial1/2.
D.The collection of data has stopped.
A.LFI
B.LLQ
C.RSVP
D.WFO
E.WRED
A.The PRI field should contain the Cos value of 010
B.The PRI field should contain the Cos value of 011
C.The PRI field should contain the Cos value of 100
D.The PRI field should contain the Cos value of 101
E.The PRI field should contain the Cos value of 110
F.The PRI field should contain the CoS value of 111
A.protection against denial of service （DoS） attacks at infrastructure routers and switches
B. protection against known worm attacks in routers and switches
C.quality of service （QoS） control for packets that are sourced from the data plane of Cisco routers and switches
D.quality of service control （QoS） for packets that are destined to the control plane of Cisco routers and switches
E.quality of service （QoS） control for packets that are destined to the data plane of Cisco routers and switches
A.WLSE supports centralized configuration.
B.WLSE supports distributed configuration.
C.WLSE can pick up statistics on a device even if the device is not properly configured.
D.WLSE can be used to upgrade the firmware on APs and bridges.
E.WLSE monitors device fault and performance conditions but cannot report any policy misconfigurations
A.H323
B.UDP
C.RTP
D.TCP
E.Media Gateway Control Protocol (MGCP)
F.session initiation protocol (SIP)
A.FXS
B.FSO
C.E&M
D.auxiliary port
E.802.3af ethernetports
最新試題
Which three benefits are realized by implementing Wireless LAN Solution Engine （WLSE）？（）
For delay sensitive traffic， what are the three best ways that are used to prevent packet loss？ （）
SDM creates a low latency queuing （LLQ） service policy with its associated classes. What are the two types of low latency queuing available using the SDM QoS wizard？（）
What are two ways to minimize the delay of VoIP packets that are traversing a network？ （）
End-to-end QoS is maintained in the Cisco WLAN deployment model by utilizing what parameter in lieu of 802.1p？（）
Which of the items stated is typically the most expensive method of improving QoS across WAN links？（）
Which two statements are true about Voice over IP （VoIP） packet delivery in a digital infrastructure？ （）
What is the term that is used to describe the process of converting a signal from digital to analog？（）
When Cisco SDM is used to generate QoS policy， various QoS classes will be created and assigned a percentage of the interface bandwidth. Which three statements indicate the default bandwidth values that are assigned by SDM for outgoing traffic on a WAN interface？ （）
Which two statements are correct about the signaling methods that are utilized for transmitting voice？ （）