A.Prevents head-of-line blocking
B.Uses less memory
C.Increases forwarding performance
D.Simplifies configuration
您可能感興趣的試卷
你可能感興趣的試題
A.Inserted between the MPLS label stack and the Layer 3 payload
B.Inserted between the MPLS label stack and the Layer 3 Header
C.Inserted between the MPLS label stack and the Layer 2 payload
D.Inserted between the MPLS label stack and the Layer 2 header
A.BGP route-reflector should be in forwarding path of data coming from its clients
B.BGP route-reflector does not have to be in the forwarding path of data coming from its clients
C.BGP route-reflector will stop reflecting the routes if they’re not directly-connected clients
D.None of the above
A.Failure detection
B.Failure reporting
C.IGP LSP/LSA originatio
D.Per-hop flooding time of new link state
E.Number of hops that need to be notified of new link state
A.MPLS LDP must be enabled.
B.BGP routing protocol must be running.
C.Named access-lists must be configured.
D.Symmetrical routing is required.
E.Domain name must be defined
A.Allows incoming TCP connections destined to port 179
B.Allows incoming TCP connections sourced from port 179
C.Allows incoming TCP connections from 1.1.1.1 and destined to，or sourced from port 179
D.Allows incoming TCP connections from 1.1.1.1 that are destined to port 179
E.Allows incoming TCP connections from 1.1.1.1 that are sourced from port 179
A.First （most significant ） octet is FF in hex
B.Starts with a prefix of FE80 to FEBF in hex
C.Starts with a prefix of FECO to FEFF in hex
D.Second octet contains a 4-bit multicast scope field
E.Last 64 bit contains the modified MAC address of the Ethernet interface
F.Is allocated from the unicast address space
A.port tunneling on the Ethernet subinterface
B.VLAN tunneling on the Ethernet trunk
C.port tunneling on the Ethernet interface
D.VLAN tunneling on the Ethernet VLAN subinterface
E.port tunneling on the Ethernet trunk
A.Tunnel label
B.VC-label
C.5-byte ATM header
D.Payload
E.4 byte ATM header
F.Support for 30 packed cells
A.In Anycast RP， two or more RPs are configured with the same IP address on loopback interfaces.
B.Anycast RP provides redundancy and load-sharing capabilities.
C.Routers with Anycast RP can be configured statically （loopback 1.1.1.1）with the command ip pim rp-address 1.1.1.1
D.Routers with Anycast RP can be configured statically （loopback 1.1.1.1）with the command ip rp-address pim 1.1.1.1
E.Routers with Anycast RP can be configured statically （loopback 1.1.1.1）with the command ip anycast-rp pim 1.1.1.1
A.PPP over Ethernet
B.Cisco Express forwarding
C.MPLS traffic Engineering
D.IS-IS routing
E.Unicast Reverse Path Forwarding（uRPF）
最新試題
What layer of the TMN （telecommunications management network） model does CTM fit into？（）
Which statement about the use of Route Target Rewrite is true？（）
MPLS label mapping on an LSR is displayed by which IOS command？（）
Cisco IOS XR Software Multicast Routing Implementation， which three features are supported in IPv6 onCisco CRS router？（）
Which information is carried in the OSPFv3 intra-area Prefix LSA？（）
Which configuration prevents traffic that is sourced from the unique local address scope to be sent out ofthe link to the upstream service provider？（）
Which option describes a benefits of IPv6 VPN Provider Edge？（）
Which tree of these are types of Ethernet Virtue Connections （EVCs） in the MEF concept？（）
What is the BGP synchronization rule？（）
Which two requirements to deploy 6PE and 6VPE solutions are mandatory？（）