多項選擇題Which destination addresses will be used by Host A to send data to Host C?()

A. the IP address of Switch 1 
B. the MAC address of Switch 1
C. the IP address of Host C
D. the MAC address of Host C
E. the IP address of the router's E0 interface
F. the MAC address of the router's E0 interface


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which of the following are types of flow control?()

A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing

2.多項選擇題Which of the following IP addresses fall into the CIDR block of 115.64.4.0/22?()

A.115.64.8.32
B.115.64.7.64
C.115.64.6.255
D.115.64.3.255
E.115.64.5.128
F.115.64.12.128

3.多項選擇題

An administrator is unsuccessful in adding VLAN 50 to aswitch. While troubleshooting the problem, the administrator views the output of the show vtp status command, which is displayed in the graphic. What commands must be issued on this switch to add VLAN 50 to the database?()

A. Switch(config-if)# switchport access vlan 50
B. Switch(vlan)# vtp server
C. Switch(config)# config-revision 20
D. Switch(config)# vlan 50 name Tech
E. Switch(vlan)# vlan 50
F. Switch(vlan)# switchport trunk vlan 50

4.多項選擇題Which statements describe the routing protocol OSPF?()

A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.

5.多項選擇題What information does a router running a link-state protocol use to build and maintain its topological database?()

A. hello packets
B. SAP messages sent by other routers
C. LSAs from other routers
D. beacons received on point-to-point links
E. routing tables received from other link-state routers
F. TTL packets from designated routers

6.多項選擇題OSPF routing uses the concept of areas. What are the characteristics of OSPF areas?()

A. Each OSPF area requires a loopback interface to be configured. 
B. Areas may be assigned any number from 0 to 65535.
C. Area 0 is called the backbone area.
D. Hierarchical OSPF networks do not require multiple areas.
E. Multiple OSPF areas must connect to area 0.
F. Single area OSPF networks must be configured in area 1.

7.多項選擇題Which are valid modes for a switch port used as a VLAN trunk?()

A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding

9.多項選擇題Given the address 192.168.20.19/28, which of the following are valid host addresses on this subnet?()

A.192.168.20.29
B.192.168.20.16
C.192.168.20.17
D.192.168.20.31
E.192.168.20.0

最新試題

At which layer of the OSI model dose PPP perform?()

題型:單項選擇題

You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()

題型:單項選擇題

Which IPsec security protocol should be used when confidentiality is required?()

題型:單項選擇題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題

Three access ports have been installed and configured to a small office.What term defines the wireless topology?()

題型:單項選擇題

At which layer of the OSI model is RSTP used to prevent loops?()

題型:單項選擇題

Which command encrypts all plaintext passwords?()

題型:單項選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

題型:單項選擇題