A.232.0.0.0/8
B.239.0.0.0/8
C.232.0.0.0/4
D.FF3x：：/32
E.FF2x：：/32
F.FF3x：：/16
您可能感興趣的試卷
你可能感興趣的試題
A.End system
B.Protocol
C.Application
D.Throughput
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A.Before sending traffic, it must first join multicast group 239.1.1.1 by sending an IGMPv2 membership report to the default router on the local subnet.
B.It must send an IGMPv2 Request to Send packet and then wait for an IGMPv2 Clear to Send packet from the IGMPv2 querier router on the local subnet
C.It may begin transmitting multicast traffic to the group only when there is no other host transmitting to the group on the local subnet.
D.It may transmit multicast traffic to the group at any time.
A.2031：0：130F：0：0：09C0：876A：130B
B.2031：：130F：：9C0：876A：130B
C.2031：0：130F：：9C0：876A：130B
D.2031：0：130F：0：0：9C0：876A：130B
A.A sham-link is a logical link between PE routers that provides an OSPF adjacency between the PE routers and forwards customer traffic across it.
B.A sham-link is a logical link between PE routers that provides an OSPF adjacency between the PE routers and carries OSPF LSAs.
C.A sham-link is a logical link between PE routers that carries OSPF LSAs and forwards customer traffic across it.
D.A sham-link is a point-to-multipoint link that provides an OSPF adjacency between the PE routers and carries OSPF LSAs.
E.A sham-link is a point-to-multipoint link that provides an OSPF adjacency between the PE routers and forwards customer traffic across it.
A.The phones are not sending traffic with the correct DSCP value.
B.The Cisco CallManager is not marking the traffic correctly.
C.This is most likely a bug on the CE routers.
D.Your LAN QoS is incorrectly configured.
A.the table of 4096 elements that map the respective VLAN to STP instance number
B.VTP version
C.configuration revision number
D.native VLAN ID
A.change the EtherChannel default hashing algorithm from XOR to use source port Layer 4 port load balancing to better load balance the traffic
B.change the EtherChannel default hashing algorithm from XOR to use destination Layer 4 port load balancing to better load balance the traffic
C.have the application recoded to use multiple connections instead of a single connection so EtherChannel can better load balance the traffic
D.upgrade the CPU and memory of the compute devices so they can better process traffic
E.upgrade the EtherChannel bundle to a single gigabit link because EtherChannel is not well suited for single-connection traffic
A.CIR=TC/Bc
B.CIR=Be/Tc
C.Tc=CIR/Bc
D.Tc=Bc/CIR
A.VRF definition for IPv6
B.MP BGP for IPv6
C.LDP
D.VRF-enabled routing protocol
E.VRF-enabled interface
最新試題
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
Which statement is correct about an OSPF sham-link？（）
An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port，100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers， resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application？（）
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one？（）
What is the STP root guard feature designed to prevent？（）
Which switch port error is an indication of duplex mismatches on 10/100/1000 IEEE 802.3u Gigabit Ethernet ports？（）
What are the "bound IP addresses" used for in LDP？（）
Choose two commands that are required to enable multicast on a router， when it is known that the receivers use a specific functionality of IGMPv3.（）
What does a unicast prefix-based IPv6 multicast address start with？（）
In which way can the IPv6 address of 2031：0000：130F：0000：0000：09C0：876A：130B be expressed most efficiently？（）