A. key mixing
B. AES-based encryption
C. anti-replay sequence counter
D. message integrity check
E. cyclic redundancy check
您可能感興趣的試卷
你可能感興趣的試題
A. The ASA is configured for Active-Standby failover.
B. The ASA is configured for Active-Activefailover.
C. The ASA is configured for Active-Active failover and a state failover link has been configured.
D. The ASA is configured for Active-Standby failover and a state failover link has been configured.
E. The ASA is configured to use a serial cable as the failover link.
F. The ASA is configured for LAN-Based failover
A. Configure the SSH version that the router will use
B. Configure the host name of the router
C. Enable AAA Authentication
D. Configure the default IP domain name that the router will use
E. Enable SSH transport support onthe vty lines
A. To selectively apply drop actions to specific interfaces
B. To enable IOS to droptraffic for signatures configured with the Drop action
C. To support load-balancing configurations in which traffic can arrive via multipleinterfaces
D. This is nota valid IOS command
A. The signatures available are built into the IOS code.
B. Toupdate signatures youneed to install a new IOS image
C. To activate new signatures you download a new Signature DefiitionFile （SDF） from Cisco’s web site
D. Loading and enabling selected IPS signatures is user configurable
E. Cisco IOS onlyprovides Intrusion Detection functionality
F. Cisco IOS-IPS requires a network module installed in your router running sensor software
A. The Pre-Block ACL is overwritten when a blockingaction is initiatied by the sensor
B. The blocking ACL entries generated by the sensor override the Pre-Block ACL entries
C. The Pre-Block ACL entries override the blocking ACL entries generated by the sensor
D. The Pre-Block ACL is replaced by the Post-Block ACL when a blocking actionis initiated bythe sensor
E. You can not configure a Pre-Block ACL when configuring IP Blockingon your sensor
A. 224.21.106.44
B. 224.25.106.44
C. 233.149.106.44
D. 236.25.106.44
E. 239.153.106.44
A. 00-00-1C-EF-00-00
B. 01-00-5E-00-00-05
C. 01-00-5E-EF-00-00
D. EF-FF-FF-00-00-05
E. EF-00-00-FF-FF-FF
F. FF-FF-FF-FF-FF-FF
A. 224.0.4.86
B. 224.4.86.0
C. 233.1.200.0
D. 239.2.213.0
E. 239.4.5.6
A. CDPmust be enabled on all switches in theVTP management domain.
B. All switches in the VTPdomain must run the same version of VTP.
C. When using secure mode VTP， only configure management domain passwords onVTP servers.
D. EnablingVTP pruning on a server willenable the feature for the entire management domain.
E. Use of theVTPmulti-domain feature should be restricted to migration and temporary implementation.
A.VTP messages are sent out all switch-switch connections.
B.VTP L2 messages are communicated to neighbors using CDP.
C.VTP manages addition， deletion， and renaming of VLANs 1 to 4094.
D.VTP pruning restricts flooded traffic， increasing available bandwidth.
E.VTP V2 can only be used in a domain consisting of V2 capable switches.
F.VTP V2 performs consistency checks on all sources of VLAN information.
最新試題
Which one of the following is NOT a supported IKE attribute？（）
What are the header sizes for point-to-point and multi-point GRE（also known asmGRE） with tunnel key？（）
What is true about SYN cookies？（）
Cisco Clean Access ensures that computers connecting to your network have which of the following？（）
Which IOS QoS mechanism is used strictly to rate limit traffic destinedto the router itself？（）
Which is a benefit of implementing RFC 2827？（）
Which statements are true concerning NAT？ （）
Which should be the key driver for a company security policy’s creation， implementation and enforcement？（）
TACACS+ authentication uses whichthree packet types？ （）
CSA protects your host by： （）