單項選擇題Customer X has a hub-and-spoke Frame Relay network， with a central office and two branch offices（RemoteA and RemoteB）. Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation，there is no connectivity between RemoteB and the central office. What is a possible solution to this issue？（）

A.Because Frame Relay IETF encapsulation is only configurable at interface level， you must use IETF encapsulation on all routers.
B.This is not a possible scenario. A dedicated Frame Relay link to RemoteB is mandatory at the central office.
C.The router at RemoteB must be replaced by a Cisco router.
D.Use Frame Relay IETF encapsulation on a per-VC basis on the central office router.
E.There is a problem in the Frame Relay cloud， because Cisco routers are compatible with IETF Frame Relay.


您可能感興趣的試卷

你可能感興趣的試題

1.問答題what is DSCP？
2.單項選擇題What is an important consideration that should be taken into account when configuring shaped round robin？（）

A.It enables policing.
B.Strict priority is not supported.
C.WRED must be previously enabled.
D.It enables WRR

4.多項選擇題The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces， but while configuring the EtherChannel in the first switch，a spanning-tree loop was detected. Which two of these procedures can avoid this problem？（）

A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.

5.單項選擇題

Refer to the exhibit. Based on this configuration， what type of marker is achieved？（）

A.Single-rate， two-color marker
B.Three-rate， two-color marker
C.Two-rate， three-color marker
D.Single-rate， three-color marker

6.單項選擇題Before inserting a new switch in the network，the network administrator checks that the VTP domain name is correct，the VTP mode is set to server， and revision is lower than the switches in the network. The administrator then configures interfaces and trunks，erases existing VLANs，and connects the switch to the network. Following that procedure，there is no connectivity in the network. What is a possible cause of this problem？（）

A.Because the configuration revision of the new switches is lower than the rest of the network， it can change the VLAN database of the other switches.
B.As a VTP server， the new switch deleted all VLANs of the network.
C.Erasing VLANs increases the VTP configuration revision.
D.Since the configuration revision of the network is higher than the new switch， the VLAN database was automatically synchronized.

最新試題

hsrp speak狀態是什么意思？

題型：?jiǎn)柎痤}

aaa架構中哪個是要求用戶輸入用戶名和密碼？

題型：?jiǎn)柎痤}

QoS機制中的分類，采用ip數據包中的哪個字段？

題型：?jiǎn)柎痤}

一堆交換機一個server、一個transpare，問配置prune在哪里配置？

題型：?jiǎn)柎痤}

what is the disadvantage of policing？

題型：?jiǎn)柎痤}

Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）

題型：?jiǎn)雾?xiàng)選擇題

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）

題型：?jiǎn)雾?xiàng)選擇題

What is the next state of initial in spanning-tree protocol？

題型：?jiǎn)柎痤}

SPT初始狀態之后的一個狀態是什么？

題型：?jiǎn)柎痤}

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）

題型：?jiǎn)雾?xiàng)選擇題