Refer to exhibits 1 and 2. A company uses a Metro Ethernet (Gigabit Ethernet) dedicated circuit to communicate between users (subnet B) and servers (subnet A) as shown in Exhibit 1. Both routers use OSPF to advertise the subnets. During a weekly management meeting, they realize that the WAN link is oversize. They have been using only 2 Mb/s in the worst-case scenario. So they propose a new, cheaper WAN connection using a 2-Mb/s Frame-Relay point-to-point link to interconnect both sites (Exhibit 2). The Frame Relay service provider informs them that multicast traffic is not allowed to run over the service provider network. Which one of these options is best to enable the company to establish the OSPF neighbor adjacency?()
A.Use OSPF network broadcast,because it uses unicast to establish a neighbor relationship.
B.Use OSPF network point-to-multipoint,because it uses unicast to establish a neighbor relationship.
C.Use OSPF network point-to-point,because it uses unicast to establish a neighbor relationship.
D.Use OSPF network point-to-multipoint nonbroadcast,because it establishes a neighbor relationship using unicast packets.
E.Use OSPF network nonbroadcast,because it establishes a neighbor relationship using multicast.
您可能感興趣的試卷
你可能感興趣的試題
哪個設備會被選為根橋?
Refer to the exhibit. When applying this policy map on the tunnel1 interface, you see packet loss for the TCP class starting at around 100000 b/s, instead of the configured 150000 b/s. What is the most likely cause of the discrepancy?()
A.The violate-action command should not be configured.
B.The current configuration of the load-interval command on the tunnel interface is preventing proper policing calculations.
C.The burst size is too low.
D.Policing on tunnel interfaces is not supported.
E.The CIR keyword is missing in the policer.
Refer to exhibits 1 and 2. In exhibit 1,all users on the LAN segment use router A as the active HSRP router. Router B is the standby router for the HSRP. In exhibit 2,the network management team reported that there is no utilization on the WAN link B. To solve this problem,you decide to change the logical topology of your LAN,but you are not sure about what changes must be made. You must manage HSRP or change it to another protocol in order to provide the most scalable design,automatic redundancy,and load balancing. Which one of these actions would be the best choice?()
A.Use MHSRP,with three users using router A as the default gateway and three users using router B as the default gateway.
B.Keep HSRP and activate PBR to redirect half of the traffic to the other WAN link.
C.Use the backup interface on the WAN link B to provide load balancing for all users.
D.Use GLBP instead,because it provides you with up to three MAC addresses for the same default gateway virtual IP address.
E.Use GLBP instead,because it provides you with up to four MAC addresses for the same default gateway virtual IP address.
Refer to the exhibit. When applying this hierarchical policy map on the on the tunnel1 interface, you measure high jitter for traffic going through class 1234. What is the most likely cause of this jitter?()
A.The configuration of a hierarchical policy map on a tunnel interface is not supported.
B.Class 5555 and class 5554 are both taking up 100% of the bandwidth, leaving nothing for class 1234.
C.The burst size for the traffic shaping is wrongly configured to 15000; this would require an interface capable of sending at 150Mb/s.
D.The burst size for the traffic shaping has been wrongly configured; it should be set as low as possible.
E.The burst size for the traffic shaping has been wrongly configured; it should be set as high as possible.
A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work?
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
A.mark VOIP traffic with IP precedence 6 and configure only ’fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the QoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VoIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
最新試題
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?()
What is method list for configure aaa?
SPT初始狀態之后的一個狀態是什么?
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配?
What is the next state of initial in spanning-tree protocol?
什么是NAT?
當將多個交換機加入到MST region當中會發生什么(what happen)?
兩ebgp鄰居發路由過來 ,哪些屬性重置?
DHCP SERVER在給一個網段設置POOL時,該網段路由器接口地址能不能放入POOL,能why,不能why。
如何實現擁塞避免?