A.Router1 has specific boot system command that instruct it to load IOS from TFTP server.
B.Router1 is acting as a TFTP server for other routers.
C.Router1 cannot locate a valid IOS image in flash memory.
D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
E.Cisco routers will first attempt to load a image from TFTP for management purposes.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?()
A.10.1.1.2
B.10.154.154.1
C.172.16.5.1
D.192.168.5.3
A.RAM
B.NVRAM
C.flash memory
D.HTTP server
E.TFTP server
F.Telnet server
Refer to the exhibit.Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?()
A.One interface has a problem.
B.Two interfaces have problems.
C.The interfaces are functioning correctly.
D.The operational status of the interfaces cannot be determined from the output shown.
Refer to the exhibit.which address and mask combination a summary of the routes learned by EIGRP?()
A.192.168.25.0255.255.255.240
B.192.168.25.16255.255.255.252
C.192.168.25.0255.255.255.252
D.192.168.25.28255.255.255.240
E.192.168.25.16255.255.255.240
Refer to the exhibit. According to the routing table, where will the router send a packet destined for 10.1.5.65?()
A.10.1.1.2
B.10.1.2.2
C.10.1.3.3
D.10.1.4.4
A.enable cdp
B.cdp enable
C.cdp run
D.run cdp
Refer to the exhibit.Based on the exhibited routing table,how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1?()
A.TherouterwillforwardpacketsfromR3toR2toR1
B.TherouterwillforwardpacketsfromR3toR1
C.TherouterwillforwardpacketsfromR3toR1toR2
D.TherouterwillforwardpacketsfromR3toR2toR1ANDfromR3toR1
A.provides common view of entire topology
B.exchanges routing tables with neighbors
C.calculates shortest path
D.utilizes event-triggered updates
E.utilizes frequent periodic updates
A.120
B.100
C.90
D.110
Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?()
A.The network administrator faled to save the configuration.
B.The configuration register is set to 0x2100.
C.The boot system flash command is missing from the configuration.
D.The configuraiton register is set to 0x2102.
E.The router is configured with the boot system startup command.
最新試題
Which three are the components of SNMP? ()
What level will be trapped if the administrator executes the command ?()
What are the three things that the Netflow uses to consider the traffic to be in a same flow ?()
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? ()
Which three statements about HSRP operation are true?()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()
What SNMP message alerts the manager to a condition on the network?()
What Netflow component can be applied to an interface to track IPv4 traffic?()