問答題ip bandwidth-percent eigrp 200 20是什么意思？

您可能感興趣的試卷

你可能感興趣的試題

4.單項選擇題Network A has a spanning-tree problem in which the traffic is selecting a longer path. How is the path cost calculated？（）

A.number of hops
B.priority of the bridge
C.interface bandwidth
D.interface delay
E.None of the above

5.單項選擇題

Refer to the exhibit. Which switching feature is being tested?（）

A.loop guard
B.PortFast
C.root guard
D.BDPU guard

6.單項選擇題Customer X has a hub-and-spoke Frame Relay network， with a central office and two branch offices （RemoteA and RemoteB）. Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation， there is no connectivity between RemoteB and the central office. What is a possible solution to this issue？（）

A.Because Frame Relay IETF encapsulation is only configurable at interface level， you must use IETF encapsulation on all routers.
B.This is not a possible scenario. A dedicated Frame Relay link to RemoteB is mandatory at the central office.
C.The router at RemoteB must be replaced by a Cisco router.
D.Use Frame Relay IETF encapsulation on a per-VC basis on the central office router.
E.There is a problem in the Frame Relay cloud， because Cisco routers are compatible with IETF Frame Relay.

8.多項選擇題The network administrator wants to enable an EtherChannel between two switches in "on" mode. The administrator connects the cables and enables the interfaces， but while configuring the EtherChannel in the first switch， a spanning-tree loop was detected. Which two of these procedures can avoid this problem？（）

A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.

10.單項選擇題Before inserting a new switch in the network， the network administrator checks that the VTP domain name is correct， the VTP mode is set to server， and revision is lower than the switches in the network. The administrator then configures interfaces and trunks， erases existing VLANs， and connects the switch to the network. Following that procedure， there is no connectivity in the network. What is a possible cause of this problem？（）

A.Because the configuration revision of the new switches is lower than the rest of the network， it can change the VLAN database of the other switches.
B.As a VTP server， the new switch deleted all VLANs of the network.
C.Erasing VLANs increases the VTP configuration revision.
D.Since the configuration revision of the network is higher than the new switch， the VLAN database was automatically synchronized.

最新試題

DHCP SERVER在給一個網段設置POOL時，該網段路由器接口地址能不能放入POOL，能why，不能why。

題型：?jiǎn)柎痤}

Local Preference？

題型：?jiǎn)柎痤}

four switches， which one will be root switch.（no pic）.

題型：?jiǎn)柎痤}

A default Frame Relay WAN is classified as what type of physical network?（）

題型：?jiǎn)雾?xiàng)選擇題

The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）

題型：?jiǎn)雾?xiàng)選擇題

aaa架構中哪個是要求用戶輸入用戶名和密碼？

題型：?jiǎn)柎痤}

When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）

題型：?jiǎn)雾?xiàng)選擇題

什么是NAT？

題型：?jiǎn)柎痤}

What is the three main step of using the QoS feature with MQC command line interface？

題型：?jiǎn)柎痤}

Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）

題型：?jiǎn)雾?xiàng)選擇題