Refer to the exhibit. In this VLSM addressing scheme, what summary address would be sent from routerA?()
A.172.16.0.0/16
B.172.16.0.0/20
C.172.16.0.0/24
D.172.32.0.0/16
E.172.32.0.0/17
F.172.64.0.0/16
您可能感興趣的試卷
你可能感興趣的試題
A.statically map IPV4 address to IPV6 addresses
B.configuration IPv4 tunnels between IPV6 islands
C.use DHCPv6 to map IPV4 addresses to IPV6 addresses
D.use proxying and translation to translate IPV6 packets into IPV4 packets
E.configure IPV6 directly
F.enable dual-stack routing
A.24
B.4
C.8
D.16
A.0.0.0.240
B.255.255.255.252
C.255.255.255.0
D.255.255.255.224
E.255.255.255.240
A.IP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9
B.IP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1
C.IP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25
D.IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17
E.IP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25
A.telnet access does not require a password
B.nat
C.no broadcast
D.chanage of destination address in the ipv6 header
E.chanage of source address in the ipv6 header
F.autoconfiguration
A.telnet access does not require a password
B.nat
C.no broadcast
D.chanage of destination address in the ipv6 header
E.chanage of source address in the ipv6 header
F.autoconfiguration
A.Global addresses start with 2000::/3.
B.Link-local addresses start with FE00:/12.
C.Link-local addresses start with FF00::/10.
D.There is only one loopback address and it is ::1.
E.If a global address is assigned to an interface, then that is the only allowable address for the interface.
Refer to the diagram. All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network? ()
A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.
A.B514:82C3:0029::EC7A:0000:EC72
B.B514:82C3:0029:EC7A:EC72
C.B514:82C3::0029:EC7A:0:EC72
D.B514:82C3::0029:EC7A:EC72
A.reduces routing table entries
B.auto-negotiation of media rates
C.efficient utilization of MAC addresses
D.dedicated communications between devices
E.ease of management and troubleshooting
最新試題
What level will be trapped if the administrator executes the command ?()
Refer to the exhibit.If the router Cisco returns the given output and has not had its router ID set manually, what value will OSPF use as its router ID?()
What are three reasons to collect Netflow data on a company network?()
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?()
What are two enhancements that OSPFv3 supports over OSPFv2? ()
What are the three things that the Netflow uses to consider the traffic to be in a same flow ?()
What command visualizes the general NetFlow data on the command line?()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? ()
Which three are the components of SNMP? ()