多項選擇題What are the possible trunking modes for a switch port? ()

A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題

Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?()

A.Switch3, port fa0/1
B.Switch3, port fa0/12
C.Switch4, port fa0/11
D.Switch4, port fa0/2
E.Switch3, port Gi0/1
F.Switch3, port Gi0/2

3.多項選擇題Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? ()

A.All ports will be in a state of discarding, learning, or forwarding.
B.Thirty VLANs have been configured on this switch.
C.The bridge priority is lower than the default value for spanning tree.
D.All interfaces that are shown are on shared media.
E.All designated ports are in a forwarding state.
F.The switch must be the root bridge for all VLANs on this switch.

4.多項選擇題Which three of these statements regarding 802.1Q trunking are correct? ()

A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex, point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.

6.多項選擇題Which are valid modes for a switch port used as a VLAN trunk? ()

A.transparent
B.auto
C.on
D.desirable

7.單項選擇題What is one benefit of PVST+?()

A.PVST+reduces the CPU cycles for all the switches in the network
B.PVST+automatically selects the root bridge location,to provide optimized bandwidth usage.
C.PVST+allow the root switch location to be optimized per vlan.
D.PVST+supports Layer 3 load balancing without loops.

9.單項選擇題

Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrator′s attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?()
 

A.Host B and the switch need to be in the same subnet.
B.The switch needs and appropriate default gateway assigned.
C.The switch interface connected to the router is down.
D.Host B need to be assigned an IP address in vlan 1.
E.The switch interfaces need the appropriate IP addresses assigned.

10.多項選擇題Which two of these are characteristics of the 802.1Q protocol?()

A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.