A.it is newer
B.it has smaller timers
C.it has less overhead
D.it is not timer-based
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which of these is applied to the Bearer class？（）
A.WRED
B.traffic shaping
C.packet marking
D.packet classification
E.FIFO queuing within the class
Refer to the exhibit. Which switching feature is being tested？（）
A.loop guard
B.PortFast
C.root guard
D.BDPU guard
Refer to the exhibit. Voice traffic is marked "precedence 5." How much bandwidth is allocated for voice traffic during periods of congestion？（）
A.a minimum of 48 kb/s
B.a maximum of 48 kb/s
C.a minimum of 48% of the available bandwidth
D.a maximum of 48% of the available bandwidth
A.loop guard
B.storm control
C.storm suppression
D.broadcast suppression
E.BPDU guard
Refer to the exhibit. In the diagram, the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios? （）
A.GE-3/1，GE-3/2
B.FE-2/1，F(xiàn)E-3/2
C.GE-1/1，GE-1/2
D.GE-4/1，GE-4/2
E.GE-2/1，GE-2/2
F.GE-3/1，GE-3/2，GE-4/1，GE-4/2，F(xiàn)E-2/1，F(xiàn)E-3/2
Refer to the exhibit. In the diagram, the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state?（）
A.GE-1/2 and GE 2/1
B.GE-1/1 and GE-2/2
C.GE-3/2 and GE 4/1
D.no ports are in the blocking state
E.There is not enough information to determine which ports are in the blocking state
A.UniDirectional Link Detection
B.Hot Standby Router Protocol
C.Virtual Router Redundancy Protocol
D.PortFast
E.root guard
F.loop guard
最新試題
DHCP SERVER在給一個網段設置POOL時，該網段路由器接口地址能不能放入POOL，能why，不能why。
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）
What is the three main step of using the QoS feature with MQC command line interface？
hsrp speak狀態是什么意思？
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配？
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）
What is method list for configure aaa？
what is four ospf area type？
four switches， which one will be root switch.（no pic）.
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）