A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
您可能感興趣的試卷
你可能感興趣的試題
A.802.1D
B.802.1s
C.802.1w
D.802.1z
A.Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot.
B.UDLD protects against STP failures caused by cabling problems that create one-way links.
C.Loop guard detects and protects against duplicate packets being received and transmitted on different ports.
D.UDLD protects against unidirectional cabling problems on copper and fiber media.
E.Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2. What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails，without using any type of EtherChannel link-bundling？ （）
A.Increase the root bridge priority （increasing the numerical priority number） for VLAN 2 on Catalyst D so that port D2 becomes the root port on Catalyst D for VLAN 2
B.Decrease the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1
C.Decrease the path cost on R2 on Catalyst R for VLAN 2 so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1
D.Increase the root bridge priority （decreasing the numerical priority number） for VLAN 2 onCatalyst R so that R2 becomes the root port on Catalyst D for VLAN 2
A.Listening
B.Learning
C.Forwarding
D.Blocking
E.Discarding
F.Disabled
Refer to the exhibit. In this network，R1 is configured not to perform autosummarization within EIGRP. What routes will R3 learn from R2 through EIGRP？（）
A.172.30.1.0/24 and 10.1.2.0/24；EIGRP only performs autosummarization at the edge between two major networks
B.172.30.0.0/16 and 10.1.2.0/24；R2 will perform autosummarization，although R1 will not
C.Since R2 is configured without autosummarization，it will not propagate the 172.30.1.0/24 route
D.172.30.0.0/8 and 10.0.0.0/8
最新試題
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?（）
SPT初始狀態之后的一個狀態是什么？
Refer to the exhibit.Which statement describes DLCI 17?（）
問一個怎么樣的屬性，能讓路由不通告給任何的peer？
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配？
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）
hsrp speak狀態是什么意思？