A.10.10.0.0/18 subnetted with mask 255.255.255.252
B.10.10.0.0/25 subnetted with mask 255.255.255.252
C.10.10.0.0/24 subnetted with mask 255.255.255.252
D.10.10.0.0/23 subnetted with mask 255.255.255.252
E.10.10.0.0/16 subnetted with mask 255.255.255.252
您可能感興趣的試卷
你可能感興趣的試題
A.數據鏈路
B.網絡
C.物理
D.傳輸
A.SW1#show swithport port-security interface FastEthernet 0/12
B.SW1# show swithport port-secure interface FastEthernet 0/12
C.SW1# show port-secure interface FastEthernet 0/12
D.SW1#show running-config
E.SW1#show port-security interface FastEthernet 0/12
A.最低端口MAC地址
B.端口的優先級號和MAC地址
C.VTP修訂號
D.最高的端口優先級數量
E.路徑開銷(cost)
A.RSTP鏈路故障后顯著減少拓撲聚合時間
B.RSTP通過增加備用和備份角色的消費STP端口角色
C.RSTP端口atates被阻塞,丟棄,learing,或轉發
D.RSTP還使用STP proprsal-協議序列
E.RSTP使用相同的定時器baseed過程STP上點至點鏈接
F.在點到點鏈路提供比STP更快的傳輸和轉發
A.VTP
B.802.1Q
C.RSTP
D.STP
Refer to the exhibit.A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands. Which two of these changes are necessary for SwitchA to meet the requirements?()
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex, point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.
A.172.31.17.4/30
B.172.31.51.16/30
C.172.31.64.0/18
D.172.31.80.0/22
E.172.31.92.0/22
F.172.31.192.0/18
A.在二層唯一確定一臺設備
B.是設備在不同的網絡中通信
C.區別二層和三層幀
D.確定設備的優先級
E.是同一網絡的不同設備可以通信
F.當不知道遠程設備的物理地址時可以查詢
最新試題
要將數據包發送到遠程網絡,應使用哪種設備?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址?()
請參見圖示。哪種邏輯拓撲是對圖示網絡的準確描述?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
何時必須使用clock rate 命令配置路由器串行接口?()