A.RIP version 1 broadcasts updates whereas RIP version 2 uses multicasts.
B.RIP version 1 multicasts updates while RIP version 2 uses broadcasts.
C.Both RIP version 1 and RIP version 2 are classless routing protocols.
D.RIP Version 2 is a classless routing protocol whereas RIP version 1 is a classful routing protocol.
E.Both RIP version 1 and version 2 support authentication.
F.RIP version 2 sends the subnet mask in updates and RIP version 1 does not.
您可能感興趣的試卷
你可能感興趣的試題
A.no VLANs
B.all VLANs
C.only VLANs 1 - 64
D.only the VLANs that are specified when creating the trunk
A.It creates a VLAN 999 interface.
B.It designates VLAN 999 for untagged traffic.
C.It blocks VLAN 999 traffic from passing on the trunk.
D.It designates VLAN 999 as the default for all unknown tagged traffic.
A.It checks the configuration register.
B.It attempts to boot from a TFTP server.
C.It loads the first image file in flash memory.
D.It inspects the configuration file in NVRAM for boot instructions.
A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains
A.session
B.transport
C.network
D.data link
E.physical
A.protocol
B.VLAN number
C.TCP or UDP port numbers
D.source switch port number
E.source IP address and destination IP address
F.source MAC address and destination MAC address
A.BSS
B.ESS
C.IBSS
D.SSID
A.Because of damaged flash memory, the router will fail the POST
B.It will attempt to locate the IOS from a TFTP server. If this fails, it will initiate the setup dialog.
C.It will attempt to locate the IOS from a TFTP server. If this fails, it will load a limited IOS from ROM
D.It will attempt to locate the configuration file from a TFTP server. If this fails, it will initiate the setup dialog.
E.It will attempt to locate the configuration file from a TFTP server. If this fails, it will load a limited configuration from ROM
A.the summarized address for all of the internal subnetted addresses
B.the MAC address of the router used by inside hosts to connect to the Internet
C.a globally unique, private IP address assigned to a host on the inside network
D.a registered address that represents an inside host to an outside network
A.VTP allows routing between VLANs.
B.VTP allows a single port to carry information to more than one VLAN
C.VTP allows physically redundant links while preventing switching loops.
D.VTP allows switches to share VLAN configuration information.
最新試題
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
On which options are standard access list based?()
Which statement describes the rule of split horizon?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
What is the default administrative distance of OSPF?()
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
At which layer of the OSI model dose PPP perform?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()