A.to verify the type of cable interconnecting two devices
B.to determine the status of network services on a remote device
C.to obtain VLAN information from directly connected switches
D.to verify Layer 2 connectivity between two devices when Layer 3 fails
E.to obtain the IP address of a connected device in order to telnet to the device
F.to determine the status of the routing protocols between directly connected routers
您可能感興趣的試卷
你可能感興趣的試題
A.Broadcasts only use network layer addressing.
B.A broadcast frame is never forwarded by a switch.
C.A broadcast address will never be the source address of a frame.
D.Broadcast addresses use an incorrect format for the switching table.
E.Broadcast frames are never sent to switches.
A.Set the SSID value in the client software to public.
B.Configure open authentication on the AP and the client.
C.Set the SSID value on the client to the SSID configured on the AP
D.Configure MAC address filtering to permit the client to connect to the AP
A.HDLC
B.Ethernet
C.Token Ring
D.PPP
E.FDDI
F.Frame Relay
A.a directly connected interface with an address of 192.168.10.254/24
B.a static route to network 192.168.10.0/24
C.a RIP update for network 192.168.10.0/24
D.an OSPF update for network 192.168.0.0/16
E.a default route with a next hop address of 192.168.10.1
F.a static route to network 192.168.10.0/24 with a local serial interface configured as the next hop
A.A CSU/DSU terminates a digital local loop.
B.A modem terminates a digital local loop.
C.A CSU/DSU terminates an analog local loop.
D.A modem terminates an analog local loop.
E.A router is commonly considered a DTE device.
F.A router is commonly considered a DCE device.
A.Switches are primarily software based while bridges are hardware based.
B.Both bridges and switches forward Layer 2 broadcasts.
C.Bridges are frequently faster than switches.
D.Switches have a higher number of ports than most bridges.
E.Bridges define broadcast domains while switches define collision domains.
F.Both bridges and switches make forwarding decisions based on Layer 2 addresses.
A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization
A.during high traffic periods
B.after broken links are re-established
C.when upper-layer protocols require high reliability
D.in an improperly implemented redundant topology
E.when a dual ring topology is in use
A.TFTP server, Flash, NVRAM
B.ROM, NVRAM, TFTP server
C.NVRAM, TFTP server, ROM
D.Flash, TFTP server, ROM
E.Flash, NVRAM, ROM
A.Filtering can occur based on Layer 3 information.
B.Broadcasts are eliminated.
C.Routers generally cost less than switches.
D.Broadcasts are not forwarded across the router.
E.Adding a router to the network decreases latency.
最新試題
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
At which layer of the OSI model dose PPP perform?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
On which options are standard access list based?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
What is the purpose of the cisco Vlan Trunking protocol?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()