When upgrading the IOS image, the network administrator receives the exhibited error messagE.What could be the cause of this error?()
A.The new IOS image is too large for the router flash memory.
B.The TFTP server is unreachable from the router.
C.The new IOS image is not correct for this router platform.
D.The IOS image on the TFTP server is corrupt.
E.There is not enough disk space on the TFTP server for the IOS image.
您可能感興趣的試卷
你可能感興趣的試題
A.Automatic summarization at classful boundries can cause problems on discontinuous subnets
B.EIGRP and OSPF are classful routing protocols and summarize routes by default
C.RIPv1 and OSPF are classless routing protocols
D.Classful routing protocols send the subnet mask in routing updates
A.to uniquely identify devices at Layer 2
B.to allow communication with devices on a different network
C.to differentiate a Layer 2 frame from a Layer 3 packet
D.to establish a priority system to determine which device gets to transmit first
E.to allow communication between different devices on the same network
F.to allow detection of a remote device when its physical address is unknown
A. It converges quickly.
B. OSPF is a classful routing protocol.
C. It uses cost to determine the best route.
D. It uses the DUAL algorithm to determine the best route.
E. OSPF routers send the complete routing table to all directly attached routers.
F. OSPF routers discover neighbors before exchanging routing information.
A.Cisco IOS IPsec/SSL VPN client
B.Cisco VPN Clinet
C.ISDN terminal adapter
D.Cisco Adaptive Security Appliance
A.The OSPF area is not configured properly.
B.The priority on R1 should be set higher.
C.The cost on R1 should be set higher.
D.The hello and dead timers are not configured properly.
E.A backup designated router needs to be added to the network.
F.The OSPF process ID numbers must match.
A.data link
B.network
C.physical
D.transport
A.A remote physical layer problem exists.
B.The host NIC is not functioning.
C.TCP/IP has not been correctly installed on the host.
D.A local physical layer problem exists.
A. 10.15.32.17
B. 17.15.66.128
C. 66.55.128.1
D. 135.1.64.34
E. 129.33.192.192
F. 192.168.5.63
A.telnet access does not require a password
B.nat
C.no broadcast
D.chanage of destination address in the ipv6 header
E.chanage of source address in the ipv6 header
F.autoconfiguration
A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.
最新試題
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()
以下哪兩種介質可提供高達1Gb/s 的帶寬?()
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()
路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()
請參見圖示。下列哪組設備僅包含中間設備?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()