單項選擇題There are no boot system commands in a router configuration in NVRAM.What is the fallback sequencethat router will use to find an ios during reload?()

A.Flash,TFTP server,ROM
B.Flash,NVRAM,ROM
C.ROM,NVRAM,TFTP server
D.NVRAM,TFTP server,ROM
E.TFTP server,F(xiàn)lash,NVRAM


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題What are three features of the IPV6 protocol?()

A.complicated header
B.plug-and-play
C.no broadcasts
D.checksums
E.optional IPsec
F.autoconfiguration

2.多項選擇題集成架構的無線安全方法解決方案有()

A.預先的威脅和入侵檢測能力能檢測無線攻擊并進行防御
B.全面保護機密數據和通信安全
C.單一用戶標識和策略簡化了用戶管理和非授權訪問的保護
D.和有線安全系統的合作確保了無線安全功能和防護的全面性

3.單項選擇題

Refer to the graphic.Computer 1 is consoles into switch A.Telnet connections and pings run from thecommand prompt on switch A fail.Which of the following could cause this problem?()

A.switch A dose not have a cdp entry for switch
B.or router JAXB.switch A dose not have an IP address
C.port 1 on switch A should be an access port rather than a trunk port
D.switch A is not directly connected to router JAX
E.switch A does not have a default gateway assigned

4.多項選擇題Which two states are the port states when RSTP has converged?()

A.blocking
B.learning
C.disabled
D.forwarding
E.listening

5.多項選擇題

What can be determined from the line of show ip route output shown in the exhibit?()

A.The next routing update can be expected in 35 seconds.
B.The IP address 10.10.10.6 is configured on S0/1.
C.The IP address 10.10.10.8 is configured on S0/1.
D.This route is using the default administrative distance.
E.The 10.10.10.8 network is two hops away from this router.

6.單項選擇題Which of these represents an IPv6 link-local address?()

A.FE08::280e:611:a:f14f:3d69
B.FE81::280f:512b:e14f:3d69
C.FE80::380e:611a:e14f:3d69
D.FEFE:0345:5f1b::e14d:3d69

7.多項選擇題Which two statements about static NAT translations are true?()

A.They are always present in the NAT table.
B.They allow connection to be initiated from the outside.
C.They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D.They require no inside or outside interface markings because addresses are statically defined.


8.單項選擇題Which command shows your active Telnet connections?()

A.show session
B.show cdp neighbors
C.show users
D.show queue

9.多項選擇題第二次體系架構的攻擊有哪些()

A.MAC地址欺騙
B.STP操作
C.MAC地址表溢出
D.LAN風暴

10.單項選擇題Which commands is necessary to permit SSH or Telnet access to a cisco switch that is otherwiseconfigured for these vty line protocols?()

A.transport type all
B.transport output all
C.transport preferred all
D.transport input all

最新試題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()

題型:?jiǎn)雾?xiàng)選擇題

在路由器上使用Router#copy running-config startup-config 命令會產生什么效果?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()

題型:?jiǎn)雾?xiàng)選擇題

OSI 模型的哪兩項功能在第2層實現?()

題型:多項選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()

題型:多項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:?jiǎn)雾?xiàng)選擇題